1998 infiti i30 3.OL the injectors not working the engine will crank but want start i can spray some starting fluid into the throttle body the engine will start and my test light will blink when the engine is running but the test light want blink when the engine is cranking what could be the problem why the test light want blink when the engine is cranking?
Once you prime it and it starts will it keep running or die again until primed ?
die again until primed i replace new spark plugs.
die again until primed i replace new spark plugs.
die again until primed i replace new spark plugs.
i disconnect TBS and the engine still want start.
With the TPS hooked back up and cranking slowly apply throttle and see if it tries to run at all .
i hooked the TPS back up and crank the engine apply throttle it didn't try to run at all, do the crank sensor operated the fuel injectors are do the cam sensor operated the fuel injectors?
Cam sensor usually has command over injectors and crank sensor for ignition coils .
can i test a Cam sensor with a digital multimeter? the noid light was connect to the injectors connection wires.
Sure . Test the cam sensor the same way as a crank sensor . Put your meter on AC Volts and crank engine over .
Did the RPM signal register when engine was running ?
yes the RPM signal register when engine was running i spray some starting fluid into the throttle body the engine started up and run for a little while i cut it of and i tried to start it up again it it will start when i spray some starting fluid into the throttle body but i also found some oil in the cam sensor where the wire connect to it will that cause the injectors not to work if oil get inside the cam sensor? ?
Clean cam sensor and it's hole and see if it helps before buying a new one .
i don't see a hole in the cam sensor
The cam sensor has a hole or recess it sets into .
×
609 views
Usually answered in minutes!
Unhook the TPS and see if it starts .
The P0120 is the TPS circuit and can cause a non pulsing signal to the injectors if it is defective .
there is no RPM when the engine is cranking.
No RPM on the scan tool PIDs or the tachometer on the instrument cluster ?
What does PIDs mean?
Parameter identification . Live information display .
Where was your test light hooked when it was blinking while running ?
i clean the cam sensor the injectors not working when the engine cranking, how do i fix this problem?
the RPM signal register when engine was running.
can you send me pictures showing how to test a cam sensor?
Should have a two wire connector . Unhook the connector and put the two leads of your meter into the connector with meter set on AC voltage . Crank engine over and post readings .
The connection pins of the sensor that is .
what number do i put the meter on? i hope to find out what is wrong with the car soon.
On AC Volts for cam sensor or crank sensor .
×