Question about Dodge Nitro

1 Answer

Please can you tell me where fuel pressure regulator lsensor ocated o. dodge nitro code coming up please cant find no info or pic

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 100 Answers

Inside gas tank

Posted on Feb 05, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: Where is the fuel pressure regulator located on an 2002 f150 v6?

in the center of the motor,in the rear on the fuel rail

Posted on Jan 19, 2009

  • 49 Answers

SOURCE: 2005 Ford Escape Rough Idle - engine code state lean fuel mixture

I recommend getting a repair manual from an auto store for your vehicle. They run $15 to $20. It will tell you exactly how to do everything you asked and also give you the values that should be expected. Hope this helps.

Posted on Feb 08, 2009

  • 92 Answers

SOURCE: fuel pressure regulator had no vacuum line connected

another engineers wet dream. think of it this way . what is normally in the intake when the engine is running.. answer vacume, hence the regulator gets its vacume without a hose connected to it as its already in a full time vacume chamber.no hose required . ps be carefull to seat the regulator and o rings securely into the housing befor you reattach the secureing metal clip.
good luck chris

Posted on Mar 23, 2009

  • 6982 Answers

SOURCE: fuel pressure regulator

Two places to look...if you have separate injectors for each cylinder then regulator should be at the front end of the fuel rail. If you have throttle body injection it is on the throttle body itself.

Posted on Jul 30, 2009

herbalgarden
  • 344 Answers

SOURCE: 95 2.5 jeep wrangler stalls consistantly and will

I had the same issue with my 4.0, I went through all the same BS you did and in the end it was a faulty fuel pump. Pricy i know but im sure thats your problem

Posted on Nov 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Please can you tell me where fuel pressure regulator sensor located o. dodge nitro code coming up please cant find no info or pic


Most Chrysler products put the pressure regulator inside of the tank with the pump and filter.

Jul 25, 2018 | Dodge Cars & Trucks

1 Answer

My husband scan our 2006 Cadillac SRX and the code reads fuel pressure regulator. Can you tell me if where this parts located. I appreciate your answer. Thanks


What DTC ? P0000 what , What engine 3.6 or 4.6 L Need more info if you would like help .
The fuel pressure regulator attaches to the fuel return pipe on the fuel sender assembly. The fuel pressure regulator is a diaphragm-operated relief valve. A software bias compensates the injector on-time because the fuel pressure regulator is not referenced to manifold vacuum. The injector pulse width varies with the signal from the mass air flow (MAF)/intake air temperature (IAT) sensor.
With the engine running at idle, the system fuel pressure at the pressure test connection should be between 380-410 kPa (55-60 psi). With the system pressurized and the pump OFF the pressure should stabilize and hold. If the pressure regulator supplies a fuel pressure which is too low or too high, a driveability condition will result.

Feb 17, 2017 | Cadillac Cars & Trucks

2 Answers

Fuel pressure high rail dodge nitro 2.8 crd


need to check the sensor circuit and your fuel regulator

Oct 25, 2016 | Dodge Cars & Trucks

1 Answer

What tests can I do to test fault code P0193, and code P0183 on my Dodge Nitro


Points to fuel temperature & pressure sensor or sensors. Simple to check, just disconnect and read ohms. May just be a loose connector or wire. Not a very expensive part to have to replace. 25315585-zejmo41uy3tce5x43qikgza0-5-0.jpg

Dec 10, 2014 | 2007 Dodge Nitro SXT

2 Answers

What could cause engine bucking 09 caravan


Sounds like a clogged fuel filter, a bad fuel pressure regulator, or a failing fuel pump.
Start by replacing the fuel filter.

Jul 25, 2014 | 2009 Dodge Grand Caravan

1 Answer

Fuel pressure sensor low rail


fuel pressure sensor has failed

Dec 16, 2013 | 2007 Dodge Nitro R/T New Cars

1 Answer

Dodge nitro diesel 2.8 will not start


have you changed the fuel filter,lately? if so first check the fuel pressure. if that is good check for injector pulse.

May 16, 2012 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

Jonah Oneal

Level 3 Expert

14059 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...