I would disconnect the battery and reconnect and see if the computer recognizes it..Also I would check my fuses.It doesn't take much to blow one.
Testimonial: "Good thoughts and ideas which led me to probe deeper and discover the actual problem is the integration relay. thanks anyway"
SOURCE: Cadillac Deville Electrical problem
You could try checking the fuses to see if any are blown, if the fuses are all good then it's possible the door switch is bad or not making a connection from dirt or debris, the door switch is generally located insdie the door at the hinge or its a push button switch, when the door closes it pushes the switch in, the switch may also be jammed in keeping your lights from turning on.
SOURCE: my door open light stays on as do interior lights
MAKE SURE YOUR INTERIOR LIGHT SWITCH IS OFF.IF ALL IS GOOD.YOU COULD HAVE A FAULTY DOOR AJAR SWITCH.
SOURCE: Power door locks and driver side power window not
You can do it yourself.
Couple of times when you replace the remote battery, you might have them not working/ responding but just follow the procedure below.
Stand close to the car, hold down the open and close knobs for about 10 seconds. Press them at the same time for 3 seconds; then press the open button as the car opens.
The above procedure is applicable to a lot of car brands. It does not matter how many knobs you might have on the remote fob.
I have carried this procedure out on a lot of brands ranging from Honda, Toyota, Rover, Ford, etc. and it works perfectly well.
Good luck and Rate this.
Cheers
SOURCE: toyota sienna interior lights not working
The problem is in the sunvisor light. You will have to take the light assembly off and you will find wires have become disconnected.
Daviscacare.com
757-689-4701
SOURCE: Power door locks and driver side power window not working
The solution to this issue was recently discovered during our most recent trip to the shop. We told them not to leave the window down when they changed the battery... BUT DID THEY LISTEN...NOOOO.
So quite by accident I was finally able to correct and then test fail the system and test and fix again...
Here you go.;
1. disconnect the battery and connect both the positive and negative cables together(after disconnected))
2. disconnect the window and lock controller in the driver's side door.
3. Leave cables connected for at least 5 minutes
4. Re-connect door window controller and locks wiring harness
5. Place the key in the ignition and turn to the run position
6. Connect Battery starting with the negative cable(ensuring not to connect then disconnect, (one swift motion)
7. open drivers side door and turn key to the off position(do not remove)
8. You should hear a series of dings
9 Once dings are heard remove the key from the ignition and you should hear the door lock solenoids activate..
10. Congrats.. Your done and the windows and locks work.
63 views
Usually answered in minutes!
×