What is the engine displacement of the truck chevrolet c-10 1975 ?

108.5Nm@5000rpm Key Specifications of Chevrolet Sail
ARAI Mileage 18.2 kmpl Engine Displacement (cc) No. of cylinder Max Power (bhp@rpm) 82.4bhp@6000rpm Max Torque (nm@rpm) 108.5Nm@5000rpm

The base engine was a rear-mounted, air-cooled, horizontally opposed six-cylinder unit displacing 145 cubic-inches and offering 80 horsepower.

215.5 cu in (3.5 L) "Thriftmaster" 1-bbl. valve-in-head 92 hp I6[1]
235.5 cu in (3.9 L) Blue Flame I6 Production 1937-1963 US
-1964 Brazil Layout Displacement 216 cu in (3.5 L)
235 cu in (3.9 L)
261 cu in (4.3 L) Cylinder bore 3.5 in (88.9 mm)
3.5625 in (90.5 mm)
3.75 in (95.25 mm) Piston stroke 3.75 in (95.25 mm)
3.9375 in (100 mm) Valvetrain OHV, 2 valves per cylinder Compression ratio 6.5:1
6.6:1 Combustion Cooling system Water-cooled Output Power output 85 hp (63 kW)
90 hp (67 kW)
92 hp (69 kW)
123 hp (92 kW)
136 hp (101 kW)
150 hp (112 kW)

https://www.quora.com/What-is-the-displacement-of-the-engine-of-a-1962-Chevrolet-C80-truck
Here is a site that you will have to open for the information.

Many engines were available for that vehicle in 72.

hello
u'd need a proper manual for this in my opinion
like there are plenty of dealers and online shops that deal in those..
you can get some free at reliable-store and it;s actually really illustrative

The 1962 Chevy Nova 4cyl was the 153-cubic-inch (2.5 L) inline engine.
It had a bore of 3.875 inches (98.4 mm) and a stroke of 3.25 inches (82.6 mm). The firing order is 1-3-4-2

what is the cubic inch displacement? they have several v-8 options

If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_4c166ba81493f541

235 cubic inch straight six and 265 cubic inch v8 .

No. The factory installed V-6's and 5.7 and 7.4 engines. In 16 years anyone could have put any Chevrolet V-8 engine in it. If you need to know exactly what engine it is there are references that identify them by engine serial number. The serial number is on the right upper face of the block just in front of the head. You can also identify any of them by pulling a head and measuring the bore and stroke. One formula for displacement is: (Bore divided by 2 x bore divided by 2 )x 3.1416 x stroke x 8 = Displacement.