SOURCE: windscreen demister
Have you taken the dash apart and checked the cable on the switch? Or tested the switch if it's electronic?
SOURCE: my demister in rear windscreen not working
Do you have rear window tinting?( the plastic sheet type ) If so,check that the edges over the demister tapes have not curled up pulling the tapes off the window and diconnecting them. If they need repair, a small bottle of tape repair solution should be available from a spare parts retailer.
El Nombre
SOURCE: my windscreen demister does not
EASY FIX HAD SAME PROBLEM WITH MY AUDI A4 2002 JUST LAST WEEK.....WILL BE ONE OF THE CONTROL MOTORS FOR AIR FLOW...UNSCREW THE 4 OR 5 SCREWS THAT HOLD THE GLOVEBOX IN PLACE TAKE CARE TO UNPLUG GLOVEBOX LIGHT WHEN LIFTING OUT...NOW YOU WILL SEE ALL THE CONTROL MOTORS RIGHT-HAND SIDE OF YOU...EACH ONE CHANGES THE AIR FLOW ...THE ONE FOR THE WINDSCREEN IS THE ONE NEAREST TO THE FRONT OF THE CAR..UNPLUG THE WIRING CONNECTOR UNDO THE 2 SCREWS NOTING HOW THE MOTOR SHAFT ENGAGES...EASY....IF YOUR UNSURE WHICH CONTROL MOTOR IT IS TURN ON YOUR BLOWERS AND TEST EACH ONE..SIDE VENTS, DEMISTER,ETC...TRY AND GET A SECONDHAND CONTROL MOTOR FROM SCRAP YARD...DEALERSHIP PRICES JUST A JOKE.. FOR A CHEAP TINY MOTOR NOT MUCH BIGGER THAN A MATCH BOX OVER A £100 SCRAP YARD £5 POUNDS...........HOPE THIS WILL BE OF SOME HELP TO YOU...
SOURCE: mercedes w202 heater control unit not responding
there is a vacuum hose off that controls the vents
SOURCE: Renault Clio Sport 182 Air Con and fan blower fault
I also have a 53 clio with climate control and the fan stopped working. After being quoted £104 by dealership I decided to have a go myself. Bonnet up, remove driverside scuttle cover. Unplug fan resistor 7701051272 (large plug with black wire to fan)remove securing screws and resistor. Dismantled casing and peeled away gel from soldered side of circuit board around mosfet transistor-desolder and remove. Mine was a N342AD 75344G but the nearest I could get was HUF75337P3 from Maplin £1.68. This was the wrong 'package size' but I managed.Close the clamp slightly (before)to hold transistor firmly and then insert transistor and solder. Reassemble. After I got an email from a scrappy QUOTING £20 if you don't fancy the messing about.
Ian
98 views
Usually answered in minutes!
×