SOURCE: 4 Faults detected on engine diagnostics check
Try first unplugging battery cable for ten minutuse, to reset ECM, and do a scan again, there are too many unrelated error codes at the same time
SOURCE: 2000 sunfire has p0336, p0340, p0130, where to
p0130 is an oxygen sensor code.
p0340 is your camshaft position sensor code
p0336 is your crankshaft position sensor code
as far as the p0130 code those usually are what i call neglected sensors that do not get replaced when they should be. this sensor is expensive but worth the money as it will help on fuel mileage.
on to the camshaft position sensor, i would start here with this. replace that sensor and when you are replacing it, inspect the sensor and make sure the electrical wires going into it are in good shape. after replacing those 2 sensors, go to a parts store who can erase your codes to turn the light off and then let us know if it comes back on and then we will go from there on the repair.
SOURCE: fault code p0245 puegoet 406 turbo fault
My book shows that P0245 is the super/turbo charger solenoid "A" voltage is low.
Testimonial: "cheers for that x18wheeler60 thought it was low pressure not voltage,dont suppose you no which selonoid might be causing this nightmare."
SOURCE: Nissan x-trail fault codes that
p0725=engine speed input circuit.p0826=up and down switch input circuit.ime not sure what the other 2 codes are sorry.
SOURCE: ABS FAULT WITH NISSAN TERRANO YREG
Had same fault - was damaged wiring in loom at back of engine where main engine harness meets the bulkhead.
There is a screened cable grey/pink that houses the two O/S/F ABS wires blue and pink. The loom copex cuts through the ABS cable causing this fault. Take a look at link below:
http://www.bba-reman.com/forums/Topic79424-1-1.aspx
637 views
Usually answered in minutes!
×