2002 ford explorerv wont crank... help!!!!!!!!!!!

Ideas and videos.

https://www.google.com/search?q=2002+Ford+Explorer+no+crank+no+start

..

Douglas, 90 lb-ft is ball joint nut torque.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

How To Install Upper Control Arm and Ball Joint 2002 05 Ford Explorer...

do you have smart lock? picture of a red hand in instrument panel? im sure they do. If so ****** in park hold key to start position & hit dash upwards & inwards on the left hand side of the steering colum if the problem is the smart lock module it will start. Common prob with fords & that is the cheap fix it will work every time you have the problem

Check your Cam,MAP,MAF sensors.

check for fuel at injectors could be fuel pump or shut off switch

The EGR valve may be stuck and dirty.........I would change it out if a little cleaner spray works..Hope this helps.

You're going to lose some coolant, so have a bucket or other container, and some fresh coolant ready. Follow the upper radiator hose to the point where it's connected to the engine. The hose is clamped to a metal housing (water inlet) which is bolted to the engine. Remove the bolts (not the hose) and lift the housing to expose the thermostat (may require a little prying with a screwdriver or similar tool). Note how the old thermostat is fitted (which end is up), lift it out of the engine, and then remove all traces of gasket from the housing and the engine. Install the new thermostat and gasket, replace the bolts, add coolant as necessary, and you're done.

Before you start the job though, check the condition of your upper and lower radiator hoses. If they show any signs of wear, fraying, or fatigue, you might as well replace them too.

BillB

I'm assuming the coilpack got wet!! Check if there is any power to the coil before changing. If thats fine, replace the coil. If there is no power, check your electrical circuit for the coil. Hopefully this helps

Does your engine turn over?When you say your upper hose blew off To me it meant your engine ran hot.You put the hose back on and filled the truck with water.So you drove it to the shop?Did you have to tow the truck after this happened?I don' know what to say! It seems like you have a blown head gasket,or you blew your engine,I need more info to help you.

No it sounds like your water pump bearing has worn causing the leak.Change the water pump.