How do I disable the alarm on my '98 Isuzu Rodeo Ls?

camshaft position Sensor location???

Isuzu SUV Forum https://www.planetisuzoo.com > threads > camshaft-po...
Jun 23, 2009 - It is located on the inside surface of the front of right cyl head. 2000 Rodeo LS (stock). 78 T/A (far ...

SOLVED: Where to locate the camshaft sensor on a isuzu

Fixya https://www.fixya.com > ... > Isuzu > Rodeo
1 answer
It's on the inside of the cylinder head at the rear of the engine. Will be hard to see it because the intake plenum hides it. where to locate the camshaft ...
Doesn't include: LS ‎' Must include: LS

Where is the camshaft position sensor in my 2002 Isuzu ...

JustAnswer https://www.justanswer.com > Car Questions
May 13, 2020 - My son is a mechanic and the Haynes manual says it's under the lower intake. Need to verify. Share this conversation.
1 answer · Top answer: you are welcome

• 
  

  Isuzu Rodeo: WHERE IS AND HOW TO MEASURE THE ...

  https://www.justanswer.com > Car Questions
  Mar 30, 2013 - If you are just testing the sensor, you can check the cam sensor signal at the ECM on pin 11 of connector number 2. It is the same blue wire.
  
  ..

Just take out the hole sys
And wire ignition wires back together
All they do is disable fuel & power to ignition

You can't disable a factory alarm system short of completely rewiring the whole electrical system and writing and installing the software programs it runs on.

If you have a valet feature on the alarm, turn it on and that should stop the alarm from sounding. Your best bet is to get a replacement remote and use it to disable the alarm correctly.

A 98 Isuzu rodeo alternative alternative little key does that work the alarm system

This has to do with the Auto's Computer system and should ONLY be done by a Factory Rep who knows what he/she are doing. not a home mechanic chore!!

NO! Call a salvage yard, they have info. on what will fit it.

it is probably a brake adjustment problem

There is a separate computer box for the car alarm, try disconnecting the wiring harness that goes to it.

I had the same thing happen to me when I lived in Las Vegas. Mine was a 98 Rodeo also with factory alarm. I took it to a shop but they said it was the radio waves that caused it to go off and I could buy a new one. I had to take my horn fuse out b/c i didn't know what else to do at the time. Then I moved and I never had the problem again.