Cars & Trucks Logo

Related Topics:

Anonymous
Anonymous Posted on Jun 09, 2018
Be the first to answer

2010 Forester LHD (European model). Where is driver side kick panel and how can I access it?

Need to access two wires behind the drivers side kick panel to program my new remote key fob to lock and unlock work.

Answer This Question

5 Related Answers

Anonymous

  • 82 Answers
  • Posted on May 04, 2009

SOURCE: Car will not unlock.

To get inside the car .... Use the key in the lock cylinder, unlock the drivers door to get inside. You shouldn't have to reprogram the fob unless it or the keyless module was changed. There may be a blown fuse that supplies the keyless control module (check the owners manual for location). or wires that lead into the Drivers door may be damaged ... The keyless module is located inside the drivers door at the bottom behind the door panel ... do the unlock/lock and trunk release switches on the inside of the drivers door operate the locks and or trunk release? If so it is not the fuse ... and not the wires to it ... And it could be your BCM body control module, located in the dash board to right of your gas petal. Because the number entry keypad (code for that is on the inside of the right passenger trunk bracket arm) also doesn't work I assume it's not the key fobs themselves. Your 98 manual is correct for your car.

Ad
boysor2933

Boyet Soriano

  • 293 Answers
  • Posted on May 28, 2009

SOURCE: remote key fob does not unlock or lock car

It may just be a battery problem. Replace the battery of your remote fob. If it will not work, try to reposition the controller beneath the dashboard.

Anonymous

  • 2559 Answers
  • Posted on Aug 04, 2009

SOURCE: My key fob remote will not unlock car doors but will start car

Here you go.If you can't read it I can email it to you.
c2293a3.jpg

Anonymous

  • 1986 Answers
  • Posted on Aug 20, 2009

SOURCE: Installing replacement side mirror on 2007 Subaru Forester

yes... you'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you can access the bolts holding the mirror on and disconnect the wiring harness as well..

Anonymous

  • 713 Answers
  • Posted on Aug 24, 2009

SOURCE: 2008 Tahoe-Remote won't lock or unlock the Drivers side lock

more than likely the lock solenoid in the driver side door is not working. it located near the latch inside the door.

Testimonial: "Thanks"

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

2010 Isuzu KB-250D. Where is the computer box located please?
https://www.google.com/search?q=2010+isuzu+kb250d+ecm+location

..
Read full answer
Apr 12, 2023 • Isuzu Cars & Trucks
0helpful
1answer

2010 Toyota Tacoma 4.0 Access Cab. What 2 wires do I connect to in driver side kick panel for a pop and lock electric tailgate opener?
if it were me and i'm not a pro.. remove the driver side door panel and i would waste a little more wire and wire it straight into the power door lock on the drivers side that way you should avoid and computer issues as you know you are wired in behind the relays again I'm not a pro i'm just a weekend shade tree guy
Read full answer
Jan 08, 2023 • 2010 Toyota Tacoma
0helpful
1answer

Find.the fuse box that located in side the driver side door
You give no make, model or year, kinda hard to assist you. the common locations are behind a driver side footwell kick panel, under the dash or behind a panel just to the left of the steering column.
Read full answer
Oct 06, 2016 • Cars & Trucks
1helpful
1answer

Location interior fuse panel
Couple of places to check for you. It should be on the drivers side down by the feet behind a concealment panel. Either on the bottom of the dash under the steering wheel or behind the kick panel by the brake pedal. That panel will pull off.
Read full answer
Jan 26, 2016 • 2010 Jeep Patriot 2.4
0helpful
1answer

Where is the code reader port on the 2008 Mitsubishi Endeavor?
It is under the driver's kick panel. Occasionally, they are under the passenger's kick panel. (Remember, the Japanese drive from the right-hand side and some car designs are not switched over completely for our LHD in NAFTA countries and Continental Europe.) The socket has 21 pins on it as I remember.
Read full answer
Mar 21, 2015 • 2008 Mitsubishi Endeavor
0helpful
1answer

How to fix b0019-0d
There are two junction connections on the four wire harness that runs from the SDM (airbag controller under driver seat) to the passenger side airbag (I/P module). Once connection is just below the passenger side airbag in the dash and another is behind the driver side kick panel.

In my case, the connector behind the driver side kick panel had likely a bit of corrosion and there was high resistance that thre the service airbag message and light on the dash. Once I cleaned this connection, the light was gone and the problem is now fixed.

High resistance in either of these connections will throw the B0019 OD code.
Read full answer
Dec 18, 2014 • 2010 Chevrolet HHR LS
0helpful
1answer

No tail lights can't find the revelant fuse
depending on year and model but just about all of toyota and lexus tail light fuse is located on the drivers side lower dash panel behind a coin holder,or a little access door that will pull out.also on the drivers side lower kick panel down towards the under side of the dash is another fuse block....if you need more info let me know and give me the year and model.........let me and fixya know if iwas any help to you and a thumbs up and a comment would be appreciated..........good luck and have a blessed day.......let me know if i can help.......
Read full answer
Jun 23, 2011 • Toyota Pickup Cars & Trucks
4helpful
1answer

On a 1998 expedition, where is the pcm and the ecm--5.4 litre
1998 Ford Truck Expedition 4WD 5.4L EFI 8cyl

PCM Ford's Location:
* Ranger - behind instrument panel (cowl), center to both driver and passenger sides.
* Explorer/Mountaineer - behind instrument panel (cowl), (access from engine compartment dash panel) on passenger side to center of vehicle.
* All other F-Series, Expedition/Navigator - lower dash panel on passenger side.
* Excursion - lower dash panel on driver side.

The PCM is behind the glove box and has a big harness connector in the firewall that you access from the engine compartment.

REMOVAL & INSTALLATION

a927c58.jpg

Fig. 1 The calibration number will be needed to order such parts as a replacement PCM, various sensors, and almost any emission control component. Typically this number is attached to a label found on the driver's door or the door pillar
1997-00 F-150, F-250, Expedition and Navigator

00a02b5.jpg

Fig. 2 Loosen the connector retaining bolt and remove the PCM connector

2cda058.jpg

Fig. 3 Remove the passenger side front door scuff plate

1fe310f.jpg

Fig. 4 Remove the passenger side kick panel

234c3f5.jpg

Fig. 5 Remove the PCM bracket clip and remove the PCM
  1. Remove the battery and the battery tray.
  2. Loosen the connector retaining bolt and remove the PCM connector.
  3. Remove the passenger side front door scuff plate.
  4. Remove the passenger side kick panel.
  5. Remove the PCM bracket clip.
  6. Remove the PCM.
To install:
  1. Installation is the reverse of removal.
  2. Tighten the PCM connector retaining bolt to 36-44 inch lbs. (4-5 Nm).

Hope helps.
Read full answer
Jul 13, 2010 • Ford Expedition Cars & Trucks
5helpful
1answer

Installing replacement side mirror on 2007 Subaru Forester
yes... you'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you can access the bolts holding the mirror on and disconnect the wiring harness as well..
Read full answer
Aug 20, 2009 • 2007 Subaru Forester 2.5X L.L. Bean...
45helpful
2answers

Dome light dosen't work the dioed needs replacing
The diode for the interior dome light is located behind the driver's side kick panel. You have to remove the kick panel or get access to the wires behind the panel. The diode is located in the wrapped wires just to the left of the fuse box area. When you feel around the wrapped wires with your fingers, you will feel a small hard rectangular plastic piece behind the tape wrapping the wires. Carefully cut the tape at the spot and locate the diode. Remove the diode and replace with a new one (about $13-18 at Kia dealer) and test. Retape with electrical tape and replace kick panel and you are done. About a 15 minute job.
Read full answer
Feb 05, 2009 • 2004 Kia Sorento
Not finding what you are looking for?

View Most Popular

Cars & Trucks

Related Question

2010 Isuzu KB-250D. Where is the computer box located please?

  • Isuzu Cars & Trucks

74 views

Ask a Question

Usually answered in minutes!

Popular Questions

How do I replace headlight on 2006 subaru tribeca

2006 Subaru B9 Tribeca

1999 Subaru Legacy Sedan.. speedometer works

1999 Subaru Legacy

Where are the fuse boxes on subaru

1996 Subaru Impreza

Loud whistle noise from roof rack

2008 Subaru Impreza Wrx

ABS Light and Check Engine Light on, Cruise light flashing

2006 Subaru Outback

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
Http://www.caaquebec.com/DocumentLibra...

2007 Subaru Forester...

PDF Manual
Http://www.who-sells-it.com/images/cat...

2008 Subaru B9...

PDF Manual
Http://www.who-sells-it.com/images/cat...

2006 Subaru B9...

Loading...