Need schematic for installation of 454 canister switch for 2007 Silverado 4.8L engine...help

Anand Kumar

• 2035 Answers
• Posted on Aug 14, 2008

SOURCE: need schematic for location of ECM on 2002 Chev Silverado 5.3L GAS ENGINE

Please use this link :

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152801b6773


Good luck...

SOURCE: Need transmission info for 1988 Chevy Silverado 454 C3500 dually

My 1988 Chevrolet C3500 With A 7.4L (454) engine has a TH400 in it.

SOURCE: need a picture or schematic

I can't give you a schematic but i can tell you where the wires should go;Battery post of the alternator should go to the center post of the battery splitter box that splits between the engine and the house.In the alternator plug the wire closest to the battery post of the alternator needs to go to the charge light or an ignition source.The other pin in the plug can just be looped the the battery post of the alternator.If you have no power to the alternator but do have power to the box that splits the power from vehicle to house the you need to put all the wires on the post marked batt until you can get a new one,this should get you up and running.If you are planing to remain camping with the temporary repairs made then separate the wires until you are ready to start the camper to prevent a dead battery condition if the house battery gets run down.Hope this helps.

SOURCE: Need a diagram of how to re-install the cooling

are you sure there are any cooling lines that go to the ps