SOURCE: reset change oil indicator
1] Press the SETUP button to display PRESS SELECT TO BEGIN SYS. CHECK.
2] press the SELECT BUTTON to display OIL LIFE---PRESS RESET IF NEW OIL
3] press and hold the RESET button to displayOIL LIFE START VALUE SET TO XXX% is displayed. The oil life is now set to 100%
SOURCE: reset oil change indicator 2008 mercedes benz E350
With the key in position 1, hit the odometer reset button on the left on the cluster 3 times in a row. The cluster should beep once. scroll through the multifunction display with the page buttons until the display shows the onboard voltage screen. It will say something like "UB: 12.2 V" scroll threw this menu with with the up/down until you reach the "service menu" page. scroll down to "confirmation" press +, confirm full service with +. Wait till it says service confirmed. cycle the key off and then back on to position 2. Scroll to the normal service menu where it normally says how many days or miles till next service. If the service was reset correctly, it will say "service display not possible" for a few minutes while it recalculates. You must cycle the key off and back on before it will back out of the onboard diagnostic mode. If you dont back out, the esp/abs/bas lights will illuminate when the car is started
SOURCE: Step by step in how to do a oil change on a 93
1) Warm up engine slightly
2) Remove drain plug from oil pan - oil drains into receptacle you have placed underneath it.
3) Allow oil to drain for a while
4) Remove the old oil filter and install a new one, being sure to lubricate any rubber seals with fresh oil prior to installation.
5) Re-install oil drain plug
6) Add 1/2 quart less than the total capacity of your oil as specified in your owner's manual
7) Run the car for a minute or two inspecting for leaks
8) Stop the engine, allow the engine to sit for approx 3 minutes
9) Check the oil level on the dipstick and add to the full line.
10) Take your old oil to be recycled
Done!
SOURCE: HOW CAN I RESET SERVICE INDICATOR O MERCEDES C220 CDI 57 PLATE
Hi,
Google found THIS:
Turn key to position 2. press the button to show the service due light. release button. turn key off. press and hold the same button to view the service light, within 2 second turn key to position 2. wait up to 10 second and the light will reset to show new service. This may take a couple of trys (make sure the doors are shut).gL,
Td
93 views
Usually answered in minutes!
×