How do i install a new 264ab sensor, ambient air temperature sensor, on a 2011 chrysler 200. i have googled and looked in my haynes manual and can not figure it out. please help

SOURCE: 99 oldsmobile intrigue

The ambient temperature sensor going bad causes this exact problem. I've replaced many of them because when they show outside temp as being below 60 degrees, the A/C control module will shut the compressor off.

SOURCE: Climate control air conditioner stops working due to incorrect ambient air temperature

Same car, same problem. Press MODE, FRONT and REAR buttons together to reset tempreture. You probably need to replace the sensor GM part number 15047946 it is in the front grill email me for a picture. [email protected]

SOURCE: sensor locations

air intake look at snorkel it could be part of mass air flow check intake for eng coolant

SOURCE: how to replace ambient air sensor on 2001 Dodge

most ambient air sensors for your inside temp display are in the grille area behind the grille the only other temp sensor for ambient air temp is in the intake duct for the engine.

SOURCE: Outside temperature reads 50 at all times

if your outside temp is wrong on your 2002 Envoy here is how you fix it. part number 15047946 sensor. looks like the wrong part..it's not. take the brace part off of it by pressing the clips and slide out the part you need. Loosen the 4-5 bolts from the top of the grill..attached to brace right on top of the grill..just pull the grill out about 3 inches..put your hand thru..it's driver side to the middle. original is grey box with connector. pull it out, reattach connector to new part and push the new piece in the hole..get the piece from the dealer..25.00...put screws back in grill brace. reset the temp by pressing front defrost, rear defrost and mode all at once. took me 15 minutes..and I'm a 55 year old girl:) you can do it!