Canapy would not come in. Used electric screw driver and brought in. It had been raining and when we got home we let it out with screw driver to let it dry. It will not come back in. There was no information provided on it when we bought it. It is a Solera LC1
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
can you remember back to the other times it quit . was it raining or very hot. see if there is anything in common . these kind of problems can realy make you pull your hair out. unless you can make it act up. oh yes humidity can also make a difference. good luck paul
look up in the corner of the visor where it mounts.. usually there is a small screw there .. raise the visor up in place and tighten the screw..it should stay up..if not ..use a bit of velcro on the visor and the headliner above it..cheap fix but it works..also invest in a windshield cover they are only a few bucks and work for other uses also.. they make a great emergency mat if you need to look under the car on naty ground(rain, snow, mud,etc)
Obviously water is the cause. Make sure all hood seals and underbody splash shields are in place, check firewall main connector for security. After it rains (without driving it in rain) check floor mats inside for water. A possible windshield or dash leak is allowing water into electrical area near instrument cluster (windshield may need resealed). Lift hood and look for water on any electrical connections disconnect dry, and seal with tune up grease from parts store. Good luck
have a look to see if its coiled in twisted as you pull the belt out if the buckledoesn't line straight to the female end well its probelyretracted in twisted to repair pull the belt out all the way and then realign the belt its quite hard to do so take your time hope this helps.
the central locking control unit is in the drivers door. there's a polythene sheet in the door panel. If that's ripped or petrified then rain may be screwing with the electrics. it may be worth taking off the door panel and wrapping it the controll unit in a shopping bag or summat.....