Where do the number six coil go to in the

Invalid Code on a Lincoln L/S 2003 up

Cylinders on Fords go

A,B,C,D,E,F,G,H
1,2,3,4,5,6,7,8
PO301,PO302,PO303 etc

All the same thing

PO308,Number 8 & on other fords H---are the same

number six is on the v6 ls is on the drivers side closest to the firewall. To replace the # 6 coil on the V6 remove the plastic appearance cover. there are two little plastic screws that hold it on if u press the little circle in on the screws they come off. then u remove the #6 coil with a 8mm socket it only has one bolt and pull it off it has a wire connector u have to press it together next to the wire and it slides out. then put the new one in. I would replace the spark plug too.

Check this diagram for details 2002 Lincoln LS 3.9 liter DOHC V-8 VIN "A"



Hope this helps.

No 6 coil is the second from the front of the engine at the right bank of engine , facing the engine from the front for Lincoln LS 3.9 / V8

Hello dognkew: My name is Roger and I will help you. looking at the engine from the drivers side fender. Number six cylinder would be the second plug back from the front of the head.Drivers side head.
Should you need further help please just ask. Please rate the answer you received as this is our way of knowing the answer was correct. Thank You for using Fix Ya. Roger

its not a easy job, but you need to get the gasket so it wont leak, theirs some tutorials online, if you dont want them to burn out, dont put the covers back on when you change them, it creates a suction and heat which makes oil spill and burn the coils

303-07A: Engine Ignition — 3.0L (4V) 2001 Lincoln LS Workshop Manual DESCRIPTION AND OPERATION Engine Ignition The electronic ignition (EI) system is a coil-on-plug (COP) ignition system.
---------------------------------------------------------------------------------------
SECTION 303-07B: Engine Ignition — 3.9L 2001 Lincoln LS Workshop Manual
DESCRIPTION AND OPERATION Engine Ignition The electronic ignition (EI) system is a coil-on-plug (COP) ignition system
-----------------------------------------------------------------------------
v-8
SECTION 303-07B: Engine Ignition — 3.9L 2001 Lincoln LS Workshop Manual
REMOVAL AND INSTALLATION Ignition Coil Removal

1. Remove the air cleaner outlet tube. For additional information, refer to Section 303-12 .

1. Remove the bolts and the ignition coil cover.

1. Disconnect the electrical connector from each ignition coil.

1. Remove the ignition coils.
   1. Remove the bolts.
   1. Remove the ignition coils.

------------------------------------------------
v-6

SECTION 303-07A: Engine Ignition — 3.0L (4V) 2001 Lincoln LS Workshop Manual
REMOVAL AND INSTALLATION Ignition Coil Removal

1. Remove the engine appearance cover.

1. To access the RH bank ignition coils, remove the upper intake manifold. For additional information, refer to Section 303-01A .

1. Disconnect the electrical connector from the ignition coils.

1. Remove the bolts.

1. Remove the ignition coils.

please rate as fixed if this helps.

sorry no diagram but rather simple on either side of the engine there are plastic covers in the middle of the valve cover take that off to expose the coil packs disconnect them and the spark plugs are right there in the well i beleave a 5/8 deep well socket and a couple extentions and u should be good

this is a photo of your engine's firing order.

It is on the Driver side of engine in between the COP's (Coil on plugs) simply unplug the wire use a 19 or 3/4 deep well socket and unscrew it and put it new one... The whole process should only take 10-15 minutes.