2009 chevy aveo, brake in lock, the battery clicking sound but lights on. then heard clicking inside glove box and found yellow circuit.it was possessed. could not turn it off even w/ keys out of ign.

SOURCE: 92 Nissan Pathfinder brake lights stuck on

Change the brake light switch on the brake pedal arm. Go down to the parts store and ask for a new brake liight switch for your Pathfinder and look up under the dash where the brake pedal arm goes and you will see the switch. You will need to unplug the wires to your old one and disconnect it and install the new one the same way. It is pretty much self adjusting once the brake pedal is released. If the brake light does not go out adjust the switch pin to be longer so it will depress when the pedal is released

SOURCE: 1997 chevy blazer wont start

same just happend 2 me,was told it was the neutral safety switch -but didnt start in neutral-took 2 shop 400 later it was the ignition switch runs great again hope i helped

SOURCE: 2001 Chevy Impala won't start

If the battery has gone dead, it could cause the security system to go into full lock-up mode. If it has locked up the accessories will work after the battery is charged back up , but the power to the starter will be cut off and it wont turn over. You need to do the 30 minute learn procedure. A GM dealer will print it out for you and you can do it yourself. It's very simple if you follow the procedure exact. hope this helps and good luck.

SOURCE: 2009 Hyundai Sonata-clicking noise at brake pedal,brakes applied

This is not a rich mans car so its normal. Your hearing the solinod that lets you take the car out of park after the brake is depressed so the car can't be put in gear unless the brake is on. If the noise bothers you the soliniod can be found and wrapped in insulation like a rich mans car them you can ride on feeling like a rich man too. ( the Beatles sang that a long time ago) and its still true today.

Testimonial: "Thanks. Dealer hasn't been helpful. I'll see how far I can go before I run out of patiencs."

SOURCE: My 1995 Chevy Lumina will not start

sounds like you have a lame solenoid on the starter .i'd start there.get a voltage tester and test for 12 volts at the solenoid terminal if there is 12 volts and the starter still doest engage when you hit the key test the ignition wire on the solenoid when you turn the key it should apply 12 volts as well .if works then take the starter out and find a good repair shop and try a new solenoid first then the starter is next to test .