2005 Honda Accord LX
Could have other maintenance issues. Emissions etc. Try to have the maint. light reset & see if it comes back on. PS do u have a check engine light or just a maint light? Ck owners manual or reset.
Look up reseting a 2005 Honda accord oil change light. There is usually a forward bkward roll of the key in a timed sequence.
SOURCE: Maintenance light is blinking for a while in 2005 honda accord
To reset your light do the following:
1-Push maintence reminder button in and hold it in. (thats the button near the speedo on the insturment cluster)
2-Turn the ignition to the on position while holding button in.
3-Wait several seconds until the light goes out, then let go of the button.
It is now reset
Now this is the maintaince light and not the check engine light correct? If then just follow above and do that.
Also if you don't use Fram oil filters you can go 5000miles on your oil and be safe. Even honda says you can do 7000miles but 5000 gives you a buffer if you need to go over.
SOURCE: reset maintenance light
If I remember correctly, on the dash you have a select button. Hold the button down then turn the key on, until the maintenance light blinks and goes out. Turn the key off then back on and your light should be out.
SOURCE: 1992 Honda Accord (LX) Instrument Cluster Replacement
Same as 2 dr, or a stick.
There are bezel screws that hold the plastic trim (pointing up towards the windshield), you nee to remove these 2 screws. The bottom section is clipped in. Tilt the steering wheel down as far as it will go.
Once you have the bezel off, there are 4 screws holding the cluster to the dash. Remove them and gently pull the cluster forward. Reach around (expect to get scraped knuckles) and unclip the speedo cable, and two large multipin connectors. Don't force anything.
Getting the cluster out after this point is a test of your patience. It only seems to come out one particular way.
SOURCE: 2005 honda accord brake light does not work
have you checked the switch under the dash at the top of the brake pedal?? they come loose so may only need adjusting ........the pin on the switch has to be clear from the pedal to work if it still makes contact when you press pedal down then that will be the prob, if it still does not work when pin is clear of plate , take cable of switch and bridge them together if that works it the switch....... if still no lights fault is in the wiring loom/ relay or light unit
SOURCE: 2005 Honda accord check engine light. is there a
Auto Zone can scan for free. There is a lot of sensors that can triger a fault code.
175 views
Usually answered in minutes!
×