Reason for above indicators
SOURCE: 2006 RAV4 warning lights
I fixed my problem with my RAV4 by going to another website that really did have free advice and didn't try to sell me any information.Thanks anyway
SOURCE: lexus ls430 2004 tire pressure indicator
Contrary to popular belief the indicator light does not reset itself. Once you put in the proper tire pressure in all tires including the spare you must reset the indicator light. The reset button is located on the driver side underneath the dash panel. Stick your on the break pedal, turn and look up. You will see the reset button. With th engine on and park break on,push and hold te button for 5 seconds. The indicator light will turn off and you are all set.
SOURCE: Warning lights on a 2006 toyota rav 4 32,000 miles
I had the same problem. A computer check showed that the emission system was having difficulty. The catalytic converter had to be replaced. The car had under 80,000 miles on it so it was covered by a warranty (State law? Federal law?).
My battery was also dead. That was replaced free too. It had a 7 year warranty.
I do NOT purchase extended warranties.
SOURCE: Toyota Avalon 2006, I ahve a VSC indicator light
VSC is Vehicle Skid Control. The system is usually on, but when you turn it off (on my mother's 01 Avalon, it's on the knee bolster, below and to the right of the steering column), the indicator comes on in the cluster to let you know it's turned off - it's just a reminder to you that you don't have that safety net activated. The way the car is set up, even if you turn it off, when you shut down the engine and then restart it later, the system is rearmed automatically.
What I'm thinking is, since you've obviously had the engine on and off and the VSC OFF and TC OFF warnings are still illuminated, you probably have a problem with either an ABS sensor, a yaw sensor, or something related to those, as those systems rely on a bunch of sensors to work. If they have failed, it should illuminate the check-engine light. Stop at Auto Zone or Advance Auto Parts and have them scan the car's computer (it's free). They'll give you a list of the fault codes that come up. If you post them up here, I can define them for you and help you solve the problem - just post them as a reply or follow-up on this posting.
Testimonial: "Thanks a bunch!! Big help and I will do what was suggested to solve the problem. Thanks again."
SOURCE: 2002 Aztek Service engine light on & high beam indicator flashes
The high beam light flashing means you have a high beam burnt out. It flashes when you put it in gear because your high beams actually double as your daytime running lights, only on a lower power.
1,991 views
Usually answered in minutes!
×