1993 Toyota Tercel Logo

Related Topics:

P
Phillip M Mendoza Posted on May 24, 2018
Be the first to answer

Brake light switch removal for 1993 Toyota Tercel.

Answer This Question

5 Related Answers

Anonymous

  • 379 Answers
  • Posted on Jan 19, 2009

SOURCE: firing order of 1993 toyota tercel

firing order is 1 - 3 - 4 - 2 , # 1 being closest to the timing belt or chain side of the engine .
4841217.jpg

great picture of wiring of the plug wires .

J5

Ad

Anonymous

  • 1959 Answers
  • Posted on Jun 20, 2009

SOURCE: 96 toyota tercel rear brake repair

They tend to get really stuck, especially if they haven't been changed in a while. A few raps with a hammer on all sides will usually get the job done. Best of luck.
Greg

Pierre Laplante

  • 2061 Answers
  • Posted on Aug 07, 2009

SOURCE: 1993 Toyota Tercel oil

yes no problem thse engine comsume oil a lot 10w30 is ticker then 5w30 so it will take less oil .pierre

Anonymous

  • 1986 Answers
  • Posted on Oct 07, 2009

SOURCE: How to change a third brake light bulb for 1993 Toyota Camry?

open the trunk and look up along the top of the bumper and you should see two screws / nuts that secure the light assembly.

Anonymous

  • 431 Answers
  • Posted on Apr 05, 2010

SOURCE: no low beams toyota tercel

This could be caused from bad dimer switch/ lost ground for high beams / or is it possible both of your high beams are bad? have you used a test light at the light to verify no power and good ground?

Testimonial: "good advice "

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the fuel pump in a 1993 toyota Tercel?
Hi ! Allen Clark The fuel pump is located in the tank. You will need Pliers, a Phillips screw driver, a 14m and 13/16 wrench. Remove the back seat. Pry off access cover and you will see the top of the tank. Disconnect the 3 lines that go to the fuel pump. Remove 8 Phillips screws, and carefully pull out fuel pump assembly. Remove and replace strainer and pump. Reverse procedure for installation. NOTE: you will need silicone to reseal access cover.
Read full answer
Oct 04, 2018 • 1993 Toyota Tercel
0helpful
3answers

My 1995 Toyota tercel brake lights stay on even when the car is off
There is a switch/sensor located at you break pedal, when you hit the breaks this has a small pin that make positive contact telling your break lights to come on. It may be broken or stuck, check it.

Also check all the bulbs on your car, breaks and blinkers etc...
Read full answer
Oct 03, 2016 • 1995 Toyota Tercel
0helpful
1answer

Brake lights stay on and won't shut off when car is turned off
Brake light switch is staying on. Autozone will replace it for you.
Read full answer
Dec 23, 2014 • 1993 Toyota Tercel
0helpful
1answer

85 tercel parking brake light stays on
I am assuming you mean the red light on the dash that says "brakes".
That light is powered by the parking brake switch and the pressure switch for the hydraulic brakes. If the parking brake is on, or the brake fluid is low, the light comes on.
Read full answer
Dec 15, 2012 • 1985 Toyota Tercel
3helpful
1answer

My back lights won't turn off on my toyota tercel
  • Push the driver's seat as far back as possible, allowing you to lay on the floor on the driver's side.
  • 2 Shine a flashlight at the top of the brake pedal stalk and find the stoplight switch. It will be a plastic cube either connected to the brake stalk or directly opposite the brake stalk, depending on the vehicle.
  • 3 Depress the brake pedal and feel where the brake light switch contacts the stopping plate, a metal plate in direct line with the stoplight switch.
  • 4 Feel for an open hole where the stoplight's plunger-style button presses. If a hole is present, you simply need to replace the rubber stopper.
  • 5 Press and release the plunger-style button on the brake light switch and ask an assistant if the brake lights are turning off and on. If not, the switch is bad and must be replaced.
Stoplight Switch Stopper Replacement
  • 1 Clean out any remaining debris left behind by the old stopper from the hole that the stopper goes into.
  • 2 Press the new stopper into the hole on the metal plate until it snaps into place.
  • 3 Shine the flashlight on the stopper and check that it sits flush against the metal plate.
  • 4 Press and release the brake pedal and ask your assistant if the brake lights are turning off and on.
  • 5 Replace the stoplight switch if the lights continue to stay on.
Stoplight Switch Replacement
  • 1 Loosen and remove the bolts holding the stoplight switch in place. It could be between one and four bolts depending on the vehicle.
  • 2 Pull the stoplight switch from its mount. Disconnect the wiring harness from the stoplight switch by pressing or pulling the locking tab and puling the harness away from the switch.
  • 3 Plug the wiring harness into the new switch until the locking tab clicks into place.
  • 4 Place the new switch on the mount the old switch was removed from and tighten the bolts with a ratchet and socket.
  • 5 Press and release the brake pedal several times and have your assistant check for proper operation.
Read full answer
Oct 31, 2011 • 1993 Toyota Tercel
1helpful
1answer

What's wrong with my car the brake lights won't go off even if the car is off?
hi,

Looks like your brae switch is not working.

Check the brake switch at the top of your brake pedal, on the steering column.

Replace the switch and your brake light will surely turn its light out!

Thanks for using Fixya!
Read full answer
Dec 14, 2010 • 1993 Toyota Tercel
0helpful
2answers

Brake lights have a mind of their own
Have you replaced the brake light switch, it sounds like it sticking. good luck
Read full answer
May 27, 2009 • 1993 Toyota Tercel
0helpful
1answer

1993 Toyota Engine Light Comes On
My sister have the same vehicle and when the light comes on i change the sparkplug and wires, distributor cap,rotor and air filter , usually the light go off. If the problem persist take the car to the nearest autoshop to do a computer check. GOOD LUCK!
Read full answer
Jan 31, 2009 • 1993 Toyota Tercel
0helpful
1answer

How do I change the rear window brake light?
In the trunk on the Part that is Directly Under the Rear Window look up. There will be Screws or Bolts that hold that 3rd Brake light. Remove these and remove the Brake Light. There should be a removable connector on the Electric Lines going to the Light. If so just Unplug and Plug in the New ones. If not, Cut the Wires and Match the Colors with the New Light.
Read full answer
Jan 05, 2009 • 1993 Toyota Tercel
0helpful
1answer

Brake and tail lights
Tercel 93 have two fuses pack, in left side motor and inside car next to open capot, check all your fuses.
Read full answer
Jun 11, 2008 • 1993 Toyota Tercel
Not finding what you are looking for?

View Most Popular

1993 Tercel

  • Cars & Trucks

Related Question

Where is the fuel pump in a 1993 toyota Tercel?

  • 1993 Toyota Tercel

139 views

Ask a Question

Usually answered in minutes!

Popular Questions

Torque specs for toyota tercel

1998 Toyota Tercel

1995 to 1999 Tercel Service/Repair Manual

1995 Toyota Tercel

Toyota tercel 1997 repair manual, Hi I'm trying to

1995 Toyota Tercel

Torque specs for 1998 tercel 1.5L

1998 Toyota Tercel

Where is the EGR valve

1997 Toyota Tercel

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...