SOURCE: 2001 chevy venture lost key
You must get a new key from the dealer. Bring in the registration, and photo I.D. Then they will cut you a key. After that, try this procedure....
GM technicians on-line
SOURCE: 2001 Ford Expedition: inexpensive new ignition (transponder) key?
the old keys or another expedition key can be reprogrammed to your vehicle, the only thing is you would have to change the lock cylinder to match the key or swap the ignition from another expedition with that has the key
SOURCE: How do I program my key for my 2006 Chevy Impala?
Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.
Originate New Master Key (PK3 or PK3+ key)
1. Insert new key into ignition cylinder and turn it to the ON (RUN) position.
The security light on the dash will illuminate and stay on for ten minutes.
2. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back to the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
3. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back on the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
4. After the security light has gone off the third time, the key has been programmed
into the vehicle’s computer and will operate the car. It has replaced ALL the
previous electronic key codes and is the ONLY key programmed into the
vehicle’s computer.
Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.
SOURCE: transponder key issue
Try disconnect battery for 30 minutes. Sounds like new key not synced with computer. Might need reprogram.
SOURCE: Key remote stopped working
I HAD THE SAME PROBLEM, CHANGED OUT BATTERIES IN MY REMOTES AND HAD THEM TESTED AND THEY WORKED FINE. THEY DEALERSHIP STATED IT WAS NOT UNDER WARANTY AND IT WOULD COST $600 TO FIX IT. YOU CAN ONLY REPLACE IT THRU A CHEVY DEALERSHIP. KIND OF A SCAM!
1,632 views
Usually answered in minutes!
×