Question about Lincoln Cars & Trucks

1 Answer

Wipers won’t shut off on my 2003 Lincoln Town Car

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Lincoln Master
  • 15,575 Answers

Do you know how to test automotive electrical circuit's ? Viewing wiring diagrams an using a DVOM - digital volt ohm meter ? Free wiring diagrams here . http://www.bbbind.com/free-tsb Enter vehicle info. year , make , model an engine . Under system click on body & accessories , then under subsystem click on wiper/washer . Click the search button then the blue link.
An using factory pin point diagnostic's .

  • The wipers stay on continuously
  • Windshield wiper motor.
  • Multifunction switch.
  • Circuitry.
  • Go To Pinpoint Test B .
PINPOINT TEST B: THE WIPERS STAY ON CONTINUOUSLY Test Step Result / Action to Take B1 CHECK THE MULTIFUNCTION SWITCH
  • Key in OFF position.
  • Disconnect: Multifunction Switch C202b.
  • Carry out the multifunction switch component test. Refer to Wiring Diagrams Cell 149 for schematic and connector information.
  • Did the multifunction switch pass the component test?
Yes
GO to B2 .

No
INSTALL a new multifunction switch. REFER to Section 211-05 . B2 CHECK CIRCUIT 57 (BK) FOR AN OPEN
  • Measure the resistance between C202b pin 5, circuit 57 (BK), harness side and ground.
  • Is the resistance less than 5 ohms?
Yes
GO to B3 .

No
REPAIR the circuit. TEST the system for normal operation. B3 CHECK CIRCUITS 56 (DB/OG), 58 (WH), 61 (YE/RD), AND 63 (RD) FOR SHORTS
  • Disconnect: Windshield Wiper Motor C125.
  • Using the following table, measure the resistance between the windshield wiper motor C125 harness side and ground:

    Windshield Wiper Motor C125 Ground pin 10, circuit 56 (DB/OG) ground pin 11, circuit 58 (WH) ground pin 1, circuit 61 (YE/RD) ground pin 9, circuit 63 (RD) ground
  • Is the resistance greater than 10,000 ohms?
Yes
GO to B4 .

No
REPAIR the circuit(s) in question. TEST the system for normal operation. B4 CHECK FOR CORRECT WIPER MOTOR OPERATION
  • Disconnect all wiper motor connectors.
  • Check for:
    • corrosion
    • pushed-out pins
  • Connect all wiper motor connectors and make sure they seat correctly.
  • Operate the system and verify the concern is still present.
  • Is the concern still present?
Yes
GO to B5 .

No
The system is operating correctly at this time. Concern may have been caused by a loose or corroded connector. TEST the system for normal operation. B5 CHECK THE WINDSHIELD WIPER MOTOR
  • Key in OFF position.
  • Disconnect: Windshield Wiper Motor C125.
  • Carry out the windshield wiper motor component test as outlined in this section.
  • Did the windshield wiper motor pass the component test?
Yes
The system is operating correctly at this time. Concern may have been caused by binding or incorrect pivot arm adjustment. REFER to Windshield Wiper Blade and Pivot Arm Adjustment in this section. TEST the system for normal operation.

No
INSTALL a new windshield wiper motor. REFER to Windshield Wiper Motor in this section.

Posted on May 17, 2018

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
chuck943
  • 783 Answers

SOURCE: replace axle seal on 2003 lincoln town car

You have to remove the differential housing cover.
Then turn the center housing until you can see the 5/16 bolt that holds the center pin that goes thru the spider and axle gears.
Remove the bolt and center pin,be careful that the gears stay in place.
Then push in on the axles to expose the c-clips on the end of the axles and remove the c-clip.
Then remove the axle.

Posted on Mar 25, 2009

  • 54 Answers

SOURCE: 89 Lincoln Town Car's brake lights keep coming on.

YOU HAVE A FAILTY RELAY AND SWITCH IN THE CAR

Posted on Jun 30, 2009

  • 1 Answer

SOURCE: 2003 lincoln town car code p0705 & p1702 changed tr sensor only when car starts

03 Town Car transmission whines & taps on very hot days only, changed fluid filter, trans cooler & radiator. Runs great on cool on days under 90 degress.

Posted on Aug 31, 2009

jmgldsmth
  • 2005 Answers

SOURCE: 1996 Lincoln Town Car trunk motor won't shut off

under the trunk lip (directly where the latch goes into the lock jaws; remove the carpet so that you can see the side of the trunk latch; on the latch jaws (bottom) is a switch that contacts the latch (top) this switch is broken or, mis-aligned it opens (stops the trunk motor) when the latch contacts it.

Posted on Jan 16, 2010

Testimonial: "Thanks much for your speedy and knowledgeable reply."

kennyz195
  • 61 Answers

SOURCE: 2003 Lincoln Town Car - Power window switch removal/installation

SECTION 501-05: Interior Trim and Ornamentation 2003 Town Car Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 01/28/2002 Front Door Trim Panel adobe.gif Printable View (206 KB) Removal and Installation
NOTE: LH side shown, RH side similar.

  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01.
  1. Remove the window switch plate.
    a0045307.gif
  1. Disconnect the electrical connectors.
    a0044981.gif
  1. ani_caut.gif CAUTION: Use care not to damage the trim panel covers.
    Open the screw covers.
    a0045817.gif
  1. Remove the screws and the assist handle.
    a0045818.gif
  1. Remove screws and the front door trim.
    a0045819.gif
  1. Disconnect the electrical connectors.
    a0045834.gif
  1. To install, reverse the removal procedure.

2010&c18=modelyear&c20=n306887&c35=wsm%2cfront%20door%20trim%20panel%2cs3g%2c501-05%2cremoval%20and%20installation&s=1600x900&c=32&j=1.3&v=y&k=y&bw=1171&bh=582&ct=modem&hp=n&[aqe]

Posted on Apr 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a lincoln town car 2003 and I am burning a little bit of gas how can I fix this issue


Used 2003 Lincoln Town Car Consumer Reviews ' Edmunds

www.edmunds.com > ... > Town Car > 2003 Town Car
Edmunds.com Rating: 4.4 - ‎64 reviews
Nov 23, 2012 - View all consumer reviews for the 2003 Lincoln Town Car on Edmunds, ... This car gets 29 to 30 mpg on highway with ac driving at 60 mph.

Oct 14, 2015 | Lincoln Cars & Trucks

2 Answers

Is there a fuel cut off switch on lincoln town car 2003 nd where is it located


On a 2003 Lincoln Town Car, the fuel pump shut off switch ( inertia switch ) is in the trunk , on the drivers side

Oct 09, 2015 | Lincoln Cars & Trucks

1 Answer

03 Lincoln town car ticking can't hear it going down the road 4.6 engine.


Can you locate where the ticking comes from?

2003-2011 Lincoln Town Car: Used Car Review

www.autotrader.com/car.../2003-2011-lincoln-tow...
AutoTrader.com, Inc.Traditional American luxury is alive and well in the 2003-2011 Lincoln Town Car ... The2003-2011 Lincoln Town Car is powered by a 240-horsepower 4.6-liter V8 engine. ...There were some problems with the climate controls as well as some ...

Aug 09, 2015 | Lincoln Cars & Trucks

1 Answer

2003 Lincoln towncar wipers will not shut off. New switch and motor


It may have a timing board for the intermittent wipers. I had the same problem on my Tahoe...ended up changing the wand switch and the timing board before it finally worked right.

Oct 18, 2014 | 2003 Lincoln Town Car

1 Answer

Windshield wiper control module on a 2003 lincoln


Intermittent wipers are controlled by mufti-function switch (under steering wheel). However, Ford saw fit to include a 'rain sensor'. Located Windshield Front Center. Please provide more info if this doesn't help.

Sep 19, 2014 | 2003 Lincoln Town Car

1 Answer

95 Lincoln town car--intermittent wipers do not work and wipers do not go to park position-- Larry


Sounds like the slip ring in the wiper motor has a strip missing from it,if so you need a new wiper motor,parts for wiper motors are next to impossible to find.

May 09, 2010 | 1995 Lincoln Town Car

1 Answer

95 Lincoln town car--Intermittent wipers do not work and wipers do not go to park position-- Larry


I would suggest replacing the wiper control module. I would consider finding a used one from an auto wrecker. Hope this helps.

Mar 25, 2010 | 1995 Lincoln Town Car

1 Answer

Windshield wipers get slow and then quit.


It sounds like your wiper motor is dying

Oct 08, 2009 | 2000 Lincoln Town Car

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

533 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

gerry bissi

Level 3 Expert

4388 Answers

fordexpert

Level 3 Expert

5692 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...