How do i REMOVE AND REPLACE THE ALTERNATOR ON MY 95 NISSAN MAXIMA?

How To Replace The Alternator On A Nissan Maxima ...

? 4:18
https://www.youtube.com/watch?v=RijNmGtnkqM
Dec 23, 2013 - Uploaded by jimthecarguy
Replacing The Alternator On A 2000 Nissan Maxima 3.0 Liter Not To Hard With These Short Cuts.

nissan maxima alternator replacement removal ... - YouTube

? 16:18
www.youtube.com/watch?v=QMp3hEmCJp8
Feb 25, 2015 - Uploaded by ****** knuckles Automotive
1996-2003 NISSAN MAXIMA / INFINITY ALTERNATOR REPLACEMENT REMOVAL INSTALLATION.

http://www.ehow.com/how_6523412_replace-spark-plugs-1995-maxima.html
There are the steps to replace the plugs. You shouldn't need to remove the manifold.
Thanks,
Lee

No, but you do have to take the fan and shroud off. then you pull the compressor loose and pull forward.

1. Disconnect the negative battery terminal.
2. Remove the splash guard on the right side of the vehicle.
3. Loosen the alternator belt idler pulley.
4. Slip the drive belt off the alternator pulley.
5. Remove the four air conditioning compressor mounting bolts.
6. Remove the radiator fan and fan shroud.
7. Move the air conditioning compressor forward.
8. Disconnect the alternator harness connector.
9. Remove the alternator mounting bolts, and lower the alternator from the vehicle.

it got only two bolt up and bottom if you want to replaced the

alrernator the bottum one it is verey clouse to the

wetter pump

I dont think that (square one) has to turn. I dont know what you are looking at, but when all bolts are out it will come off.

HOPE THIS HELPS!!

first you need to release the belt tensioner, and remove the belt. Disconnect the battery, and remove electrical plug on aternator. Then simply unbolt the old alternator, bolt in the new one, re-attach the the electrical plug, connect the battery back up, and re-install the belt. FYI this would be a good time to replace the serpentine belt.

Remove the high tension cable to the distributor from the ignition unit. Conduct a spark test. If there's no spark, try to replace the ignition coil or the igniter.

sounds like a starter motor problem, i would change that first

maxima.org is a helpful website....

http://forums.maxima.org/5th-generation-maxima-2000-2003/546081-replacing-alternator.html