Remove the plastic hard line that supplies the fuel rail from either end. The end near the firewall is easiest but i remove both to check pressure at each end . It requires an inline connection with your fuel gauge to connect but is only way to check fuel pressure without crawling underneath which would require the same connection.
SOURCE: PT Cruiser Brake Light
The bulb in the rear light has burned out and to replace it follow these instructions: 1) go to your owner's manual to find out the part number. You can find and purchase the replacement bulb at Target, any auto parts store and even at Walmart for under $4.00; 2) pop open the trunk door; 3) get a phillips screw driver and unscrew the 2 screws holding the rear brake light fixture to your car body; 4) as soon as you turn over the fixture you'll see where to pull out the burned out bulb and replace it with the new one(s). Good luck!
SOURCE: 2001 PT Cruiser quit running driving down highway
I HAD THE SAME PROBLEM, I BROKE A TIMING BELT. HAD TO REPLACE THE ENGINE.
SOURCE: chrysler pt cruiser fuel filter location?
Under vehicle, center, below seating area, mounted on top of fuel tank, in fuel pump module
SOURCE: how will not blow on 2006 pt cruiser
1st check fuse. Then see if power is coming to horn. A simple power checker can be found at most auto parts store. It may also have a horn relay. Look up your wiring at cargrus. If you still have problems contact me back.
SOURCE: 2002 PT Cruiser fuel pump and filter
FUEL PUMP IS LOCATED IN FUEL TANK..FILTER IS LOCATED ON TOP OF PUMP MODULE..A NEW PUMP WILL NORMALLY COME WITH THIS FILTER..YOU MUST REMOVE FUEL TANK FROM VEHICLE TO REPLACE THESE COMPONENTS..IF YOUR NOT SURE YOU CAN DO THIS,I WOULD TALK TO A REPAIR SHOP..FUEL CAN BE VERY DANGEROUS
Print
CAUTION
Relieve the fuel system pressure before servicing any components of the fuel system. Service vehicles in well ventilated areas and avoid ignition sources. NEVER smoke while servicing the vehicle!
607 views
Usually answered in minutes!
×