SOURCE: put in a new wiper motor 1997 e39 528i bmw\it stops in the middle
Remove arm(s), put wiper motor in park,(shut off) then re-install arm at base of windshield where they were before,when shut off.(in park position.)
SOURCE: I require the fuse list that goes with E39 BMW
I've got a 528i, and 318i,needed the same info. Of course they're not the same but I got the info via a google search. To get the right answer you MUST ask the right question. In this case, google key words: "fuse box location and layout in a BMW 5 series" it will then give you thousands of choices, usually in the first page or two, you will get your answer
Testimonial: "You are a STAR thank you, very best regards. Les Beckett."
SOURCE: How to install front bumper cover on 2001 BMW E39
Installation
of the Molding
Take the Molding Trim whether it is
stock black or painted. Mine is black because my car is a year 2000.
Painted side moldings were done in the year 2001. Snap them into
place.
5 Installation
of the Rubber Gaskets
From the stock bumper, retrieve the upper
rubber gaskets unless you ordered new ones. Simply take a screw
driver and pry a corner off to get you started. Wash thoroughly.
NOTE which one belongs on which side.
Place the rubber gasket on the M5 Front Bumper onto
its appropriate side. Top
The M5 Bumper is now Fully Assembled!!!
Place aside where it can't be damaged.
SOURCE: BMW 530I E39 2001 MODEL AUX FAN STAYS ON AFTER
If you mean the engine coolant fan, then yes most fans will run until the engine cools down to a specific temp.
SOURCE: i try to go for top speed in my e39 540 i bmw but ...
It's because of your Motronic Unit (the computer) having self-limiters in it. If you want to change your computer's settings, go to www.bavauto.com and they sell "chips" or a programmer to allow you to reach top speeds by bypassing the limiters within your Factory Computer...known to us "Bimmer" enthusiasts as a Motronic.
Hope this Helps,
~00 Buck~
88 views
Usually answered in minutes!
×