It crank but want start sets controls stopped working
SOURCE: 2004 NISSAN MURANO CODE P0442 EMISSION
Please check out this article for further info.
Let us know if you notice any of these problems.
Brian
SOURCE: 2004 Nissan Murano How do you clear maintenance light after oil change?
press maintanence button until you see engine oil, then hold trip/reset button... :)
SOURCE: replace control panel on 2004 nissan quest
there is a c-clip you need a small screwdriver to pull it out then gearshift knob will pull off
SOURCE: 2004 Nissan Murano, back door can't open
I had a similar problem with a sienna and sometimes the cable ( inside the door) between the handle and the latch gets stuck in the sleeve. Kind of like the brake cable on a bike.
take the panel off by removing all the screws you can see on the panel and pull the panel off. There will be plastic pins holding it. Some of them may pop off and some will break off.
Drip oil down the sleeve so the cable slides freely. I used bike chain oil. Do not use WD40. This is **** and will not work for very long. Try the handles a few times before you put the panel back.
SOURCE: How to Remove Car Radio from Nissan Murano
If you disconnect one of the battery cables for about 30 sec and reconnect it, that will reset the CD player. Then you can put in the key and see if can eject the offending CD. My bet is that it won't. I own a 2006 with a failing CD (getting it replaced on warranty next week). The CD player in these cars is a real stinker. Nissan should be ashamed.
500 views
Usually answered in minutes!
×