SOURCE: warning light
Usualy the check engine light reports a malfuction in your engine performance system, it coulb be a misfire, bad sensors, vaccum leak, you need to have your engine code read from a garage or an auto parts store that offers the service for free.
SOURCE: abs warning light is on
When the ABS light is on that tells you that the ABS is not working. Start with the easy stuff, first check the fuse, then check the plug at each wheel. Every time this has happened on one of my cars it has been a plug. The brakes will still work normally you just won't have the anti lock feature.
SOURCE: My 2003 Hyundai Santa Fe ABS light is staying on
Here are all the possible problems which can turn on your ABS light.
C1101 Battery voltage over volt: 18V or more ○ ○ BR - 69
C1102 Battery voltage low volt: 9.5V or less ○ ○ BR - 69
C1200 FL wheel sensor: open or short to ground ○ ○ BR - 66
C1201 - Range/Performance: speed jump or damaged exciter ○ ○ BR - 67
C1202 - No signal: air-gap error or wrong excite ○ ○ BR - 68
C1203 FR wheel sensor: open or short to ground ○ ○ BR - 66
C1204 - Range/Performance: speed jump or damaged exciter ○ ○ BR - 67
C1205 - No signal excite: air-gap error or wrong excite ○ ○ BR - 68
C1206 RL wheel sensor: open or short to ground ○ ○ BR - 66
C1207 - Range/Performance: speed jump or damaged exciter ○ ○ BR - 67
C1208 - No signal excite: air-gap error or wrong excite ○ ○ BR - 68
C1209 RR wheel sensor: open or short to ground ○ ○ BR - 66
C1210 - Range/Performance: speed jump or damaged exciter ○ ○ BR - 67
C1211 No signal: air-gap error or wrong excite ○ ○ BR - 68
C1604 ECU hardware: ECU internal or valve failure ○ ○ BR - 70
C2112 Valve relay: valve relay or fuse failure ○ ○ BR - 70
C2402 Motor-Electrical: open or short to battery, motor relay, fuse or motor lock fail ○ ○ BR - 71
C1503 TCS switch failure δ ○
C1605 CAN Hardware failure δ ○ BR - 71
C1610 CAN Bus off failure δ ○ BR - 71
C1611 EMS Time-out failure δ ○ BR - 71
C1612 TCM Time-out failure δ ○ BR - 71
C1613 TCM Un-matching failure δ ○ BR - 71
C2227 Brake disc overheat δ ○
C1274 G-Sensor signal fail (only 4WD) ○ ○ BR - 72
C1275 G-Sensor open or short to ground (only 4WD) ○ ○ BR - 72
You'll need a scanner which is compatible with Hyundai's ABS system to retrieve any DTC's (Diagnostic Trouble Codes) stored in its computer. Any time the ABS light comes on, there's a DTC stored in its computer - that code will tell you where the problem exists. Then you can go from there.
SOURCE: 00 hyundai accent, wont start light on dash with
Could be as simple as a blown fuse for the ETACS module, but it sounds more like a problem with the anti theft immobilizer system. Does your car have remote keyless entry? And is the key you are using a factory key or one someone made? (factory key will be encased in bulky black plastic with hyundai logo) The transponder in the key might have worn out and is not talking to the car anymore. Some hyundais use the radio antenna to receive the signal, is there an antenna on the car? Is it hooked up? If it is a problem with the key and immobilizer system, It will unfortunately need towed to a dealer and reprogrammed.
SOURCE: why does the airbag light stay on
Because you have a problem in that system and need check it at mechanic shop.
179 views
Usually answered in minutes!
My guess, a sensor gone open circuit or damaged cable.
×