SOURCE: windows and lock wont operate on a 2004 Jeep Grand Cherokee
I just had the same with mine, pull the rubber boot back on the drivers side front door and look for a severed wire, mine was black...simply spliced the wires back together and problem solved!
SOURCE: 2000 Jeep Grand Cherokee Laredo Door Locks Dont' Work Correctly
you need to check wiring between lf door and body..peel back rubber boot and pull on wires..you will find 1 or more broken wires..can be repaired
SOURCE: 2002 jeep power windows and door locks stopped
SOUNDS LIKE YOU HAVE BROKEN WIRES BETWEEN DRIVER'S DOOR AND BODY AT A PILLAR..PULL RUBBER BOOT FROM BODY AND DOOR AND INSPECT WIRING HERE
SOURCE: drivers side door on 1998 jeep grand cherokee
I have the same problem. Do not know cause but I remove large red 50 fuse in engine compartment fuse box, wait 15 sec and replace. Lock car and unlock. This seams to reset something and car is fine. This problems seams to appear when my battery is low.(?)
SOURCE: windows will not work from
First thing to check is the fuses. Look underneath the drivers side steering wheel (to the left) for a covered fuse box. Remove the cover and find the fuse that controls the locks and windows and mirrors (two-three separate fuses) Pull them out "one by one" and see if they are burned out. If they are, replace them with the correct number fuse.If it is not the fuse, the door lock actuator has failed (for the door locks) or the master switch that controls the locks is bad. Go to your local junk yard and find a replacement for cheap
http://forums.automotive.com/70/16389/general-auto-repair/2001-jeep-grand-cherokee-power-windows-defect/index.html
Unlock all of the Jeep
Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Control any distant PC remotely. Test the Software now for Free!
www.TeamViewer.com/Remote_Control
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
525 views
Usually answered in minutes!
×