2002 Jaguar S-Type Logo

Related Topics:

B
Bill B Posted on Mar 27, 2018

Disable door chime on 02 Jaguar s type - 2002 Jaguar S-Type

5 Related Answers

Anonymous

  • 277 Answers
  • Posted on Aug 29, 2009

SOURCE: 02 Jaguar S Type - Heater blowing cold air

Has the vehicle overheated recently, if not there is a failure of the Coolant from engine valve controller, that measures flow through the Heater Matrix. Come back with more, as necessary.
Regards,DT

Ad

Anonymous

  • 1 Answer
  • Posted on May 30, 2010

SOURCE: Is there a passcode or sequence to disable the

yes there is, it sounds retarded, but

-Turn car keys to power up but not start the car.
-Wait till the seatbelt light goes out (about 8-10 seconds)
-Put the seat belt buckle on and off 3 times
-Turn your park lights on once
-Put your buckle on and off 7-10 times till the seatbelt light flashes rapidly
-Once the seatbelt light stops flashing
-Put the seatbelt on
-Start up your vehicle



Like i said, i know it sounds stupid, but it worked for me! Good luck!

Ig Cor

  • 2 Answers
  • Posted on Jun 28, 2011

SOURCE: 2005 pontiac sv6 door alarm

On my '07 Montana SV6 was the same problem, I've fix it by moving up to 3 mm. contact plate at the body frame of the rihgt sliding door. If you check the spots on the plate where pins from the door comes to this plate, you will see that they contacting not in a middle. There are two ways to fix: move down pin unit in the door or move up contact plate on frame. For me second way was better. It's manufacture mistake comes sinse 2005 and on right door only.

Randy Ohler

  • 14585 Answers
  • Posted on Aug 22, 2011

SOURCE: How do we disable the door ajar chime? My driver

You have to pull the door panel off. Then there are a couple of plugs that go to the door latch mounted on the jam. One of the plugs is for the chime. Pull it, but you might have to put a jumper wire in the plug. I work on a lot of different cars and seen them work both ways. So I am not entirely sure how yours works. Unplug it and if it goes off your done. if it doesn't, use a jumper wire in the plug.

sj196653

Shade Tree All Repair

  • 509 Answers
  • Posted on Apr 07, 2012

SOURCE: Door open chime

you have to look under the dash and unplug the chime from its electrical source. Just listen for it find it and pull it.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Removed door panel off of a 2002 jaguar s type and now the door open chime will not shut off help

The chime usually goes with the door latch. What did you replace? You may have not got the electrical plug seated or a lead has pushed out.
0helpful
2answers

Tried to replace dashboard cluster on my 02 plate x type jag now wont start at all and flashing up security failed can anyone please shed any light on what the problem may be thanks nigel

the instument pack is part of the pats. security system i guess the pack is saying pecus error, it needs to be programmed to the car so the other modules on the system recognise it, you need find someone with jaguar ids or compatiable diagnostic equipment to carry out this task.hope this helps.
0helpful
1answer

How to disable chime 02 Lexus sc430

i have 02 lexus sc430, need to disable roof chime
0helpful
1answer

KEYS FOR 2003 JAGUAR X TYPE

put ignition in off pos, switch on and off 4 times quickly, you will hear a chime then press a button on the fob this should reprogramme the fob.
5helpful
1answer

How can I reprogram my Jaguar X Type Key so I can unlock and lock my doors?

if your just programming the fob to the module and it has not been replaced and your just needing a manual reset,then follow the folowing procedure:

1 Insert key into ignition
2 Turn key to 'I"
3 Turn key "II" and back to 'I' quickly 4 times
4 Alarm system will chime once when key is back to 'I' for the
fourth time
5 Remove key from ignition
6 Press any button on each key fob and alarm system will chime
for each fob if it has been programmed correctly
7 Press unlock/lock/trunk etc to make sure everything works
2helpful
1answer

How do I program key fobs on a 2003 Jaguar X-Type?

Full details can be found at http//www.bluejag.co.uk Jaguar X-Type Programming (Pairing) a Remote KeyFob X-Type 2.0, 2.5 and 3.0L
keyfob.jpg

Programming or pairing a new remote Keyfob for the X Type is a very simple job that will cost a substantial amount if it is done by Jaguar. It's annoying but this may need to be done if your Keyfob battery has been allowed to go flat, or the car battery has been removed for any length of time.
Follow these steps exactly and you should have no problems, pairing old or replacement Keyfobs for your car.

1.)I would recommended that you ensure all key fobs are fitted with new batteries. ( Click here to see battery replacement guide).
2.)Get in the car and close the drivers side door.
3.)Put the key into the ignition and turn to position I.
4.)Wait 5 seconds
5.)Turn the key quickly to position II then back to I four times.
6.)You should hear a single chime.
7.)Remove the Key
8.)For each Keyfob in rapid succesion. Press any single button on the keyfob you wish to pair, you should hear a chime as each Keyfob is paired with the security system. After the chime do the next Keyfob.
9.)Check operation of each Keyfob.
1helpful
2answers

2005 jaguar type-s. How can i disable the belt minder. The seatbelt alrm is making me crazy

To enable or disable the seat belt warning chime on your 2005 Jaguar Type S

1. Ensure the front passenger seat is unoccupied.

NOTE:

Steps two to five must be completed within 60 seconds.

2. Turn the ignition to the RUN position (do not start the engine).

3. Buckle the driver safety belt buckle and wait until the seat belt warning lamp extinguishes.

4. Unbuckle the driver safety belt buckle and wait until the seat belt warning lamp illuminates.

5. Repeat Steps three and four a further eight times.

6. When the driver safety belt buckle is unbuckled for the ninth time a single chime will be heard. The single chime is acknowledgement that the beltminder feature has been disabled.

The beltminder feature will be disabled until the above process (Steps one to six) are repeated. Upon repeating the process the beltminder feature will be reactivated
0helpful
2answers

Re programme of key fob for a 2004 Jaguar x type

More infomation can be found at http://www.bluejag.co.uk Jaguar X-Type Programming (Pairing) a Remote KeyFob X-Type 2.0, 2.5 and 3.0L
keyfob.jpg

Programming or pairing a new remote Keyfob for the X Type is a very simple job that will cost a substantial amount if it is done by Jaguar. It's annoying but this may need to be done if your Keyfob battery has been allowed to go flat, or the car battery has been removed for any length of time.
Follow these steps exactly and you should have no problems, pairing old or replacement Keyfobs for your car.

1.)I would recommended that you ensure all key fobs are fitted with new batteries. ( Click here to see battery replacement guide).
2.)Get in the car and close the drivers side door.
3.)Put the key into the ignition and turn to position I.
4.)Wait 5 seconds
5.)Turn the key quickly to position II then back to I four times.
6.)You should hear a single chime.
7.)Remove the Key
8.)For each Keyfob in rapid succesion. Press any single button on the keyfob you wish to pair, you should hear a chime as each Keyfob is paired with the security system. After the chime do the next Keyfob.
9.)Check operation of each Keyfob.
5helpful
3answers

2004 xtype jaguar key fob suddenly stopped working car locked and alarmed if i use key in the door will the alarm go off if so how do i stop it

Your key fob needs reprogramming, and yes the alarm will go off when you open the door, but you have enough time to put the key in the ignition which will prevent the alarm sounding. Car is usable until you get the fob sorted by locking and unlocking using the key.
0helpful
2answers

Key/FOB programming

Jaguar X-Type Programming (Pairing) a Remote KeyFob X-Type 2.0, 2.5 and 3.0L

keyfob.jpg

Programming or pairing a new remote Keyfob for the X Type is a very simple job that will cost a substantial amount if it is done by Jaguar. It's annoying but this may need to be done if your Keyfob battery has been allowed to go flat, or the car battery has been removed for any length of time.
Follow these steps exactly and you should have no problems, pairing old or replacement Keyfobs for your car.

1.)I would recommended that you ensure all key fobs are fitted with new batteries. ( Click here to see battery replacement guide).
2.)Get in the car and close the drivers side door.
3.)Put the key into the ignition and turn to position I.
4.)Wait 5 seconds
5.)Turn the key quickly to position II then back to I four times.
6.)You should hear a single chime.
7.)Remove the Key
8.)For each Keyfob in rapid succesion. Press any single button on the keyfob you wish to pair, you should hear a chime as each Keyfob is paired with the security system. After the chime do the next Keyfob.
9.)Check operation of each Keyfob.
Not finding what you are looking for?

234 views

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...