I was told that I need it. my car would not start. after replacing the part it still want start
SOURCE: Jeep starts and runs for about five seconds then cuts off
obviously the dealer did not correctly complete the repair, therefore should be more involved in current problem. If your vehicle had any anti-theft device installed, be aware that many have delayed shut down features built in. I'd look there first, providing yo did not have any similar problem pryor to the theft.
Good luck!!
SOURCE: car wont start
I noticed you replace the crankshaft sensor, but not the CAMshaft sensor.
The Ignition module takes the input of both sensors to tell the coil when to energize.
This sensor should come up as an error code when you attach a obd reader.
Even if your light is not on - there may be a code. If it is not your vehicle originally, some people pull the bulb!
SOURCE: Ignition will not recognize the key chip and it will not start.
call a locksmith they have a reader and can tell if your key is the problem... it will tell them which keycode is for your vehicle and they can check and see if the key matches also i have a 95 ssei and the pcm was the problem with mine
SOURCE: lost ignition key and replace it, then car would not crank
That is true its part of the antitheft system.
SOURCE: service engine soon light/security light
Probably the dealer will reset the system it for free.
60 views
Usually answered in minutes!
×