I recently tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. It wont move forward or reverse, engine is good both solenoids for forward and reverse work.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.comAll the best
SOURCE: Connector for Speed Sensor on1996 Honda Accord Auto Trans.
If you are talking about just plugging into the speed sensor yes. A VTEC and NON-VTEC are one and the same.
SOURCE: locassion of output speed sensor on 2003 Town and Country
The input and output speed sensors look identical on the connector side. The one over the solenoid pack is the input, the one closer to the left frame rail or left front wheel is the output sensor. I hope this helps.
SOURCE: Transmission Speed sensor wire on 06 Ford E-350
The older vehicles have a cable that hook up to left side of tranny. New vehicles have the speed sensor on the wheels and run to ECU then to speedometer
SOURCE: flaky transmission range sensor connector
I'm not sure if it can be. Lots of these newer connectors are sold as , you know, only complete and you splice it in. Is it bad on the switch side or the body harness side of the connector? Heck, if it's just to the back-up bulbs, you could connect the two wires together outside of the connector, and bypass the connector problem on that one wire. That would be the easiest fix, as long as the other pin connections are good
Now on the older removeable spade type connectors, you slip a fine wire or needle along the top of the metal pin to push down a little tang, and then the wire and pin will pull out from back of the plastic connector.
Well, good luck, Bill.
158 views
Usually answered in minutes!
×