You will get your solution and all info on service info, repair info, parts info, wiring/electrical/fuse diagrams, error/fault codes, torque specs, PCV,
owner's/service/repair/parts/maintenance manuals etc everything
this website www.reliable-store.com
it's a very good website for vehicle problems even as old as 1991 ford..
SOURCE: body control module location
the location of the bcm is at the passenger side glove box area
SOURCE: Body Control Module
Below the instrument panel on the left side henge pillar,or up high behind the Instrument panel depending the model and options!
SOURCE: Needing to know what a BCM(Body Control Module) does.
it control warning
door locks
lights
alarm
SOURCE: 2001 mazda tribute, intermittently stalls
hi
can you tell me the model and size of the motor please.
Thanks
Jason
SOURCE: 2001 Mazda Tribute intermittently stalls at idle.
Check your EGR valve, check your PCV valve, check your mass airflow sensor and throttle body sensor.
?€¢
The ignition lock cylinder case, including the Passlock?"¢ sensor
?€¢
The ignition switch
?€¢
The body control module (BCM)
?€¢
The security indicator on the instrument cluster
?€¢
The powertrain control module (PCM)
The body control module (BCM) contains the logic of the Theft Deterrent System. The BCM provides the battery positive voltage to operate the Passlock?"¢ sensor. The BCM also measures the voltage of the security sensor signal circuit. The voltage measured will indicate whether the Passlock?"¢ sensor has been activated and whether the resistance value from the sensor is a valid value or the tamper value. If voltage measured is in the valid range, the BCM compares this voltage, voltage code, to a previously learned voltage code. If the voltage codes match, the BCM sends a class 2 message containing a password to the powertrain control module (PCM). If the voltage codes do not match, or the voltage is in the tamper range, or there is a circuit fault, the BCM will not send the correct password to the PCM, and the vehicle will not start.
The body control system consists of a BCM and it's associated controls. Battery positive voltage is provided to the BCM from CLSTR fuse in the Fuse Block-left I/P. The module ground is wired to ground G201. The BCM is wired to the Class 2 serial data communication bus as well as discreet input and output terminals to control the functions of the vehicles body !
Now then Karen what problem is your vehicle having , no start an SECURITY light flashing or on solid ?
Now then
351 views
Usually answered in minutes!
×