At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
www.ford-trucks.com > ... > Diesel > 6.7L Power Stroke Diesel Feb 3, 2014 - Starting around 25,000 miles my wipers stayed on the slowest intermittent setting even when ... They only two that come to mind is the switch inside the cab or the wiper motor control board. ... The wipers do not park at the correctposition ... It doesn't really matter what steps need to be taken to fix the issue.
CarGurusAug 31, 2015 - Window washer fluid put in window washer won't work now. ... 4 answers. wipers working, not the washer though, pulled pump, intake screen clean. 2011 Kia Sorento Base ... Interior lights do not work when door is opened 7 answers. At first the back seat overhead light stopped working. Kia said it would ...
Likely, the pump/motor for the rear window (which is located under the front washer bottle is not being turned on, or is stuck for whatever reason. Remove the exit hose from the pump and blow through it with LOW pressure air to see if fluid and air exit from the rear washer fitting. Both motors are controlled directly by the Body Control Module (another computer besides the PCM) and are not fused individually. Each motor receives 12 volt power to it when commanded to run. Hope this helps!
on the bottom of the reservour is a hose which is attached to a little pump which makes the washer fluid shoot out on to your windshield.it also has an electrical plug connected to it.sometimes by wiggling the plug it will start to work again,if not,make sure that there is power going to the pump.if there is power,your washer pump will have to be replaced.if there is no power,check your fuses. hope this information helps you with your problem. take care, manny
the pump motor likely is bad. get a used washer fluid reservoir at a pick n pull yourself or at car-part.com. page with * is lowest cost.
Pump and Reservoir, Windshield Washer
Removal
Disconnect the battery ground cable (14301).
Raise and support the vehicle.
Remove the RH wheel (1007).
Remove the RH front fender splash shield (16103). Refer to Section 01-02 for the removal procedure.
Remove the windshield washer reservoir top bolt.
Disconnect the windshield washer reservoir fluid level sensor electrical connector.
Disconnect the rear window washer pump electrical connector from the rear window washer pump.
Disconnect the windshield washer pump electrical connector from the windshield washer pump (17664).
Place a suitable drain pan under the windshield washer reservoir (17618) and drain the washer fluid.
NOTE: The rear window washer hose end is color-coded, matching the connector on the rear window washer pump. Match the colors to ensure proper installation.
Disconnect the washer hoses from the windshield washer pump and the rear window washer pump on the windshield washer reservoir.
Loosen the two windshield washer reservoir side bolts.
Remove the windshield washer reservoir by sliding it out of the side slots.
Remove the windshield washer pump.
Installation
To install, reverse the removal procedure.
Tighten the lug nuts (1012) to 98-118 Nm (72-87 lb-ft).
the pump wire is probably not making good connection with the pump that is why the washer fluid wont work try and clean the connection. the pump is located under the fill tank
check for a bad relay for the wipers not working. the relay will be under the hood or under the dash next to the fuses. the cover will tell you what piece is the relay. the relay controls the delay in the wipers so that is probably bad and you can get them at napa for cheap. and simple to install its just like a fuse.
if it is the same as a 2002 UK spec then the washer pump is situated at the bottom of the washer bottle. the washer bottle is situated behind the inner guard on the same side as the filler cap for the washer bottle. the pump is push fitted to the water bottle. if u have been using window washer additives then they can form a slime that stops the pump working. if that is the case then remove the pump and wash it under the warm tap to clean it out and refit. hope this helps oscargilpin
Rear washer pump is located near bottom of washer reservoir, below the left front wheel house extension and between left inner and outer fenders. Have some operate the rear washer switch while you listen in this area to find out if the the pump is running. The hose from the pump routes up along side the reservoir filler neck, into the engine compartment. Just aft of the reservoir neck an in-line connector joins the hose to the engine compartment hose. The engine compartment hose travels the top left front fender wheel house to the dash panel, passing through a grommet into the passenger compartment. In the passenger compartment, another connector joins the engine compartment hose, and then up through the front driver pillar to the headliner, then above the headliner along the left roof to the rear of the vehicle. It comes out above the lift gate, in the hinge gap, and into the lift gate to the nozzle.
Not likely to be stopped up. First find out if the pump is running, and that there's fluid in the reservoir. Look for fluid running out somewhere near the reservoir. The pump isn't running, or the hose is disconnected around the tank. Look for leaks (when running the pump, and reservoir filled) at the lift gate hinge joint.
×