What is the socket size for the front wheel bearing hub on a 2006 equinox

SOURCE: What size socket for a front wheel bearing hub nut

36mm

SOURCE: cannot find tool to loosen front wheel bearing lock nut

I have a 1995 Geo Tracker 4WD with the same exact problem,However I did some research . You will need to go to the Kent Moore Website which makes specialty tools and look up Wheel bearing socket "J-37763" I saw the picture of it and it looks like there are 4 small rounded teeth/tabs. Unfortunately get ready to spend some money - cost is about $70.00 not including shipping/handling
I hope that this Info. helps - Jim H.

michael schultz

• 1068 Answers
• Posted on Oct 25, 2009

SOURCE: What size socket for 2003 Dodge Dakota 2wd front

36mm if it has the factor axle still in it. if change could be a 34mm. hope that helps good lcuk

SOURCE: Remove the wheel bearing/hub assembly from the

need detailed pictures of how to change rear wheel bearings on a chevy equinox

SOURCE: Replace Front Wheel Hub Bearing 2002 Jeep Grand Cherokee 2 wheel drive

Removal

1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove the brake caliper, caliper anchor, rotor and ABS wheel speed sensor.
4. Remove the cotter pin, nut retainer and axle hub nut.
5. Remove the hub/bearing mounting bolts from the back of the steering knuckle. Remove hub/bearing from the steering knuckle and off the axle shaft.

1. Install the hub/bearing to the knuckle.
2. Install the hub/bearing-to-knuckle bolts and tighten to specification.
3. Install the hub washer and nut. Tighten the hub nut to specification. Install the nut retainer and a new cotter pin.
4. Install the brake rotor, caliper anchor, caliper and ABS wheel speed sensor.
5. Install the wheel and tire assembly.
6. Remove the support and lower the vehicle.

Testimonial: "Thanks ED.. :-)"