SOURCE: 2001 vw beetle window and door lock will not work
Hi Rachel . It sounds like the plug on the drivers window motor (Which is also the ecu for that door) has come off or is loose . This will stop the cdl working as well . Regards VW Audi tech
SOURCE: 2001 oldsmobile alero window off track,
first remove the door panel there are three screws that need to be removed first 2 under the inside door handle and 1 on the lower left hand side behind a reflector then pull off the panel it will be held on by push clips, once inside move the plastic weather bearrer to the side ,run the window half way down you should see 2 window holding brackets pull the window up so you can drop it in the brackets, first get some black window adhesive fill the brackets with adhesive put window in brackets and roll it up and leave it up for 24 hrs.If the brackets are broken you will have to replace the whole window motor assemly which you can get on line for 89.00 not the 250.00 at dealer and you can install it yourself its easy to do.
SOURCE: driver side window is off track and stuck about 75% closed
If your power window motor is not moving up or down at all inside the door panel, you will need a new motor.
If your window is stuck and will not move, it is the motor - it is bad.
If your window falls down into the door panel, the window is off track.
Replacing a window motor is an easy fix, get another one from an auto parts store and replace it.
Good luck!
SOURCE: REMOVING A DOOR PANEL
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: how to put a window back on its track in a 02 mustang
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull off the weather seal and you can readjust the window from there
340 views
Usually answered in minutes!
×