Need cylinder head torque setting for 1996 mazda b2500 diesel automatic

no year no joy, no VIN told, that tells country and year and engine,
so RTM read the manual
and
tell them vin
or?
bingo
https://eautorepair.net/Marketing/Default.asp


i must pay too. or google endless for free ones (pure luck)

What bolt is this your tightening? As long as you have applied the correct Torque setting and the correct number of Degrees you don't need to worry about the final torque reading on the bolt. For areas like cylinder head bolts the final reading will be slightly different for each bolt.

press the helpful button and try links below

http://www.aera.org/uploads/4/3/7/7/43776611/aera-torquespecs.pdf

mazda ford diesel rf r2

The above image is of the diesel 2.5 cylinder head not the gasoline motor

Diesel ?? common rail or injector pump ,either way firstly i would suspect the head gasket as it sounds like its burnt through between cylinders one and two .This is the most connon fault with any engine

What is de torque for wl 2500 mazda main bering. Thanks

Cylinder Head Torque in 2 steps [1st (50 - 60 ft-lbs), 2nd (80 - 90 ft-lbs)]

which is the model?

Mazda B2200, B2500 and B2600 (6th Generation).

In model year 1998, Mazda B series renews its own international markets. Production at the plant AutoAlliance Thailand began in May 1998. This model is also sold as the Ford Ranger in Europe and Asia, and the Ford Courier in Australia and New Zealand. Production started this year in the factories of companies AutoAlliance Thailand and Ford Motor Philippines. Versions CKD are also assembled in South Africa, Ecuador and Colombia.

The van is sold in over 130 countries under a variety of names. Along with the emblems of Fighter and Ranger in Southeast Asia (except Singapore, which served as the flagship models Proceed Japan), was sold as the Mazda Bounty and Ford Courier in New Zealand, Mazda Bravo in Australia, and Mazda Drifter in South Africa.

Engine options:
2.2 L 2.2 L (2.184 cc) 85 hp (63 kW)
2.5 L (1.998 cc) turbo diesel 118 hp (88 kW)
2.6 L (2.606 cc) 121 hp (90 kW)

Fig. Tighten the exhaust manifold bolts in 2 stages

To install:

1. Clean the mating surfaces on the exhaust manifold and the cylinder head.
   
2. Install a new gasket and the exhaust manifold. Torque the bolts in sequence as follows:
   1. 16 ft. lbs. (23 Nm).
      
   2. 59 ft. lbs. (80 Nm).

Hope helps.

call your local auto zone-they can give them to you