There is no display when I turn on the ignition and the theft lock light stays on. I have tried the one procedure with holding the 2 & 3 buttons down and writing down the code but there is no display on the radio.
Download manual from here www.reliable-store.com
SOURCE: I need to reset my
This will fix it. I just did mine. You do NOT need to pull out your stero to get the Serial Number.
If you lost the code, you may retrieve it from https://radio-navicode.honda.com/
SOURCE: new battery now radio is locked on '94 Pontiac Bonneville.
you have to call the pontiac dealer parts dept and he will tell you how to get the code you may have to prove ownership for the car because the anti-theft is activated at this time
SOURCE: My Theft Lock is stuck on and now it is in InOP stage
I suffered the same problem. Turn your ignition key to the ON position for 1 hour. This will reset the double lock feature on the radio to prevent theft. Once you leave your ignition key on for 1 hour, turn the key to the off position. Remove the key. Then turn the ignition key back to the ON position. You should then see "LOC" instead of "InOp". Then try the steps to enter your code again. Three incorrect tries will enable the double lock feature again, and you will have to repeat these steps to reset it.
SOURCE: anti theft lock on pontiac grand am need code!!
on most hondas you have to pull the radio and get the code of the back then call the dealer, however I am pretty sure on that car you just write down the vin number and call the dealer I emphasize on call so they dont charge you
SOURCE: How do I reset the anti-theft system on my 2000
disconnect the negative battery cable for about three minutes, replace, put key in ignition and turn it on, DO NOT START CAR, turn it off, remove key, reinsert key and start car
Theft Deterrent Fuel Disable Signal Received
Possible Causes:
Perform the Powertrain Onboard Diagnostic System CheckPassword Learn Procedure - Attempt to start the vehicle (leave the ignition "on"). The Theft System telltale will flash for 4 seconds and then remain "on" for 10 minutes. Theft System Learn Mode will display Disabled on the Scan ToolTurn the ignition "off" after the Theft System telltale goes "out".Repeat steps 1 and 2 two more times. After the Theft System telltale turns "off" on the 3rd key cycle, and Theft System Learn Mode will display Enabled on the Scan Tool, attempt to start the engine. Once the engine starts the password is learned.
124 views
Usually answered in minutes!
×