SOURCE: 2002 ford explorer front wheel bearing assembly
remove hub ,take retaining circlip out and knock it out with a big big hammer supporting it on an old wheel rim and a tree trunk.this job is easy to do but unless you have the right tools entrust it to a garage who will have a nice press .
SOURCE: 2002 ford taurus wtaer pump
Removal & Installation
3.0L (2V)
To Remove:
To Install:
Water pump bolt torque sequence (3.0L (2V) engine)
SOURCE: Ford Explorer 2006 Overheating
Who determined that the water pump and radiator needed to be replaced? If it was the dealer or an independent garage, bring it back and tell them they guessed wrong. You paid to have the problem fixed and they need to stand behind their work.
This is a problem that's hard to diagnose without being able to check a lot of items and ask questions, but the obvious things to look for if you have a new radiator and water pump (and hopefully a new thermostat) is for air in the cooling system which keeps the coolant from circulating. Also check to see that the cooling fan(s) are operating properly.
SOURCE: replace rear wheel bearing 2002 ford explorer 4x4
you must remove brakes, then remove axle nut, then remove upper control arm and finally tie rod stabilizer, remove axle from car then bearing can be accessed. this is a difficult job that requires special tools so be careful
SOURCE: steps on replacing a water
4.6L Engine
Fig. Water pump installation - 4.6L SOHC and DOHC engines
To install:
Engine cooling fan
Drive belt
Water pump pulley
Water pump
Pump bolts 18 ft. lbs. (25 Nm).
Pulley bolts 18 ft. lbs. (25 Nm).
Hope this helps (remember to rate this answr)
248 views
Usually answered in minutes!
×