Normally its yanking the engine or lifting it but these links should help Chevy s10 gmc sonoma 2 2 liter Oil pan removed without engine removal How to remove oil pan on 2001 s10 2 2 2wd without pulling the engine 1998 Chevy s10 oil pan gasket and rear main seal
I tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my ford explorer. it wont move forward or
reverse, engine is good both solenoids for forward and reverse work.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.com
SOURCE: Oil Pan Gasket Replacement - How to - GMC Yukon 2000
No big job Really. Just locate your Drain Plug for the Oil. Thepan is right there, Remove the Bolts around the Pan and Remove. You will lose all of your oil so, Have something there to catch it all. Clean it all around the Edges of the Block where the Pan mounts with Degreaser and Make sure that you Scrape the Old Gasket off of Both the Block and the Pan. Run a Thin Bead of Blue ATV Silicone around the Pan Edge, Lay the Gasket on top of this Silicone. Put another Thin line on top of the Gasket and Reinstall. This Silicone is High Temp Silicone and will Seal Very Well. Make sure to put oil Back in the Motor! Please Rate my Response, I need all the Help That I can Get! Thanks!
SOURCE: 1999 Saab 9-5 oil pan torque spec
they should be torqued with a 3/8 torque ratchet to 30 inch pounds.
SOURCE: 1998 GMC Sonoma threw code P1133 02S 1/1
P1133 - Heated Oxygen Sensor (HO2S) Insufficient Switching Bank 1 Sensor 1
I would have the repair shop see if they either damaged or left disconnected the oxygen sensor for engine cylinder bank one upstream sensor, this sensor would have been disconnected if the oil pan was removed.
SOURCE: 1999 GMC sonoma starte installation
2.2L Engine remove protective shields as needed then remove front exhaust pipe. Remove the brace from the engine to the clutch housing, then disconnect starter wiring. 4.3L Engine 2 wheel drive just remove the right front tire and you will have access to the wiring. 4.3L Engine 4 wheel drive you must remove the differential carrier shield if equipped then remove the starter bolts and rotate the starter to get access to the wiring. Good Luck.
1,644 views
Usually answered in minutes!
×