Question about 2003 Dodge Durango
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
the resistor is behind your glove box. open the box and push in the sides to release it and let it hang down...the resistor is right there. I didn't try to replace it, a friend did it, but the part was under $20.
Posted on Feb 01, 2009
SOURCE: 1999 dodge durango heater core
It's a big job. Drain the coolant down, recover the freon in the ac system and disconnect the lines and heater hoses. Lower the steering column, remove the instrument panel assembly, remove the heater housing. Split the case halves on the housing and there you are. Usually around 500 to 700 dollars at a dealership.
Posted on May 29, 2009
The front and rear are two different systems-if the rear works or doesn't -your front still should. Your problem is the blower motor resistor and yes you can do this yourself. Remove the glovebox door and the resistor will be fastened to the heater/ac box with 2 screws and a harness plugged into it. It is a dealer only part, but they are under $30. Hope this helps you. Will probably take about 10mins to change,
Posted on Dec 07, 2009
Since your blower is working and it is a heat issue,thats where we'll
start,First thing is have you checked the coolant level in the radiator when
engine is cold,make sure it is filled to top,next verify you have coolant in
reserve ,Start your van and get it up to normal operation temperature,If your
heat gauge on the dash works correctly it should be 190 degrees,Now lift the
hood and locate the two heater hoses going into the heater assembly at the fire
wall,Both hoses should be hot to hold on to,if both are hot and no heat inside
your problem will be the blend air door in heater assembly.
if neither hose is that hot you need to replace the thermostat in the engine to get it up to 195 degrees.
if one hose is hot and one is luke warm then the heater core is blocked and to blame. hope this helps you.
Posted on Jan 09, 2010
SOURCE: Heater Fan Only Works On High
The fan motor pulled to much current causing the resister to blow and the harness/wire to melt. So for safety reasons I just replaced it all.
Blow motor resistor harness- Part is 05017124AA
Resistor- Part is 05174618AA
Here is a link with pictures to how to replace the harness and resistor.
Thank you for using fixya and be safe.
Posted on Apr 18, 2010
Tips for a great answer:
Mar 16, 2015 | 2003 Dodge Durango
Feb 20, 2013 | 2003 Dodge Durango
Dec 27, 2009 | 2003 Dodge Durango
Dec 06, 2009 | 2003 Dodge Durango
Nov 14, 2009 | 2003 Dodge Durango
Aug 18, 2009 | 2002 Dodge Durango
May 12, 2009 | 2003 Dodge Durango
Apr 18, 2010 | 2003 Dodge Durango
Aug 01, 2008 | 2001 Dodge Durango
423 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: