Have 2004 Toyota RAV4....installed new double din stereo radio....unit powers on can change stations...indication that sound is coming through the radio but I get no sound

Page 184 of the manual? I don't see Days. All manuals are available, unless it is an aftermarket Crutchfield or upgraded unit.

https://cdn.dealereprocess.org/cdn/servicemanuals/gmc/2004-envoy.pdf

Upgrading the Stereo System in Your 2002-2009 GMC Envoy

https://www.crutchfield.ca > ... > Research Garage

Hours 7 days a week ... 2002 • 2003 • 2004 • 2005 • 2006 • 2007 • 2008 • 2009 ... Replacing the factory stereo system is a great way to make your Envoy (or ... You can replace the factory radio with a variety of single-DIN or double-DIN ... them in your own environment - that's why we offer a 60-day money-back guarantee.

..

A 1 DIN stereo is what came stock in your vehicle. A 2 din stereo is double the height of a 1 DIN stereo, but the same width.

it sounds like maybe water got in2 your computer. water is bad. chek all your fuses and relays

Its the ignition live wire! they are nearly always yellow but please check your diagram. you will need to connect it to live.

If you look on e-bay, you will find many double din stereos for sale. (double din being the larger sereo, as in double the size of the single din that we consider standard size)

YOU NEED A NEW RADIO. INTERNAL CONCERN. THEY BE SENT OUT FOR REPAIR. CK COST MAYBE CHEAPER TO BUY A AFTERMARKET UNIT OR GO TO EBAY

i have a 2002 ford escape and i bought a double din radio and it did not fit and found out it is actually a din and 3/4 with out serious mods (cutting a bigger hole in dash) double din wont fit i bought a single din stereo and a din a 3/4 dash kit works fine

Very simple. DIN size head units fit without any adapters (assuming your car has the DIN size factory radio with pocket underneath {I have '93 Paseo and this was the setup of mine, though Crutchfield.com shows option of factory stereo with pocket and without [guessing there was a double DIN size option]}). All you need is a wiring harness. I've seen these anywhere from $5 - $20. This will connect to the wires on the harness for your new radio, then instead of cutting any of the factory wiring, you simply plug the factory harness into this new socket.

The trim ring around the radio/climate control/ashtray area is held in with clips. It just pops out (may have to use a thin screw driver to get your fingers under one of the edges to start). Four screws hold the metal frame where the head unit, climate control, and ashtray are. Take those out and pull the metal frame out a bit, then disconnect the wires of the climate control, power lead to lighter, and stereo harness and antenna. Two screws per side hold the stereo in to the metal frame. Take those out, slide out the factory radio and put in your new head unit (You will not use the metal cage or any other mounting brackets the head unit may come with). The holes on the metal frame should line up with mounting holes on the side of your new radio.

Not to endorse one vendor over another, but Crutchfield.com supplies instruction sheets and any needed install accessories free with purchase of new head unit. Their prices are often slightly higher than you can find elsewhere (comparable to retail stores, usually more than online stores), but you get the wiring harness and instruction sheets for your vehicle. At the very least, you can use their site to see what fits your vehicle (Note: Many other stores do this as well.)

Single din is smaller, double din will fit better in your truck.. What radio are you looking for ?? Not to step on anyones toe's but I can help you out, I can prolly get you a better deal.. hit me up if you want.. [email protected]

You may need to replace the head unit - you can pick up a OEM replacement on ebay for about 70-100, or go to a stereo place and get a double din head unit for as much as you want.

Aftermarket head unit would probably be better anyway, and you can find a decent clarion double din head unit for less than $200, with ipod control, mp3, wma/aac, etc.. it will be better than your OEM stereo.

If you decide to replace the stereo, its really easy and would take only about 30 minutes, message me and i'll tell you how to remove the stereo.