SOURCE: Rear Windshield Wiper Problems
Check the wiper motor connection if its touching anything and loose it will automatically ground out and check at connection make sure you put some gel and then snap it in/ Please rate my response thank you very much
SOURCE: Need to change a rear window wiper motor
Remove the outer wiper arm. Remove inner tailgate coverings. Disconnect wiper electrical connector and retaining bolts to remove. Installation is reverse of removal
SOURCE: wiper motor replacement on 2004 tahoe
You need to remove your wiper arms and take off the plastic cowl panel.
SOURCE: Rear windshield wiper broken 2007 Chevy Tahoe.
Once you get the nut off of the shaft use a pair of plyers or channel locks and wiggle the base back and forth it iwll come off and then you can replace the wiper assembly without taking anything else off.
SOURCE: My rear windshield wiper stopped working on my
My 2005 tahoe did the same thing. I also bought a new motor, which did not fix. I discovered there was a bad ground. Instead of searching for bad ground, just install a short length of stranded wire with crimp terminals between a wiper motor mounting bolt and a rear glass latch assy mounting bolt to restore good grounding to the wiper motor.
1,191 views
Usually answered in minutes!
×