You can fix it by checking the disk and removing the error
how do you remove the error? I have checked all fuses, just had to replace the battery (nav was saying "please check disk, prior to replacing battery) , I have no idea where to go now. Just want to have control of my Heat and AC.
×
SOURCE: remote garage door opener
1-800-355-3515
www.homelink.com
1. Position vehicle within 10 feet of garage door- engine off and battery on.
2. Press/hold 2 outside buttons of Homelink
transceiver until red indicator starts flashing rapidly, then release
button. This should take about 20 seconds. This erases any previously
learned codes.
3. Press/hold remote control and press/hold button of Homelink transceiver simultaneously. Slowly move remote control from 5" away to 1" away from Homelink
transceiver. Release both buttons after red indicator starts blinking
rapidly. This should take about 5 seconds. I discovered that the Homelink in my TL is a bit faulty because it took much longer to accomplish this than when programming the Homelink in my MDX. My TL's Homelink
may "unlearn" it's code in the future and the needed proximity of the
TL to the garage door may be much closer than desired until I get the Homelink fixed.
4. Press training button on garage door opener unit until the indicator lights illuminates- this should be immediate.
5. Within 30 seconds press/hold the Homelink
button for 2-3 seconds until the red indicator starts flashing rapidly.
Repeat a second time. It should now be programmed. Check it by pressing
the programmed button on the Homelink receiver.
6. When programming more than 1 garage door opener unit, disconnect
power from unit before programming more units. By not doing this the
programmed unit could conflict with the unprogrammed units commands.
Problems:
1. The Battery in the garage door remote may be too weak to program Homelink.
However, the battery may be strong enough to operate the garage door.
One of my remote controls had a weak battery- my system was installed
today, fresh out of the box. I had to use the second remote control for
the programming of Homelink on my 2 vehicles.
2. Antenna on the garage door opener unit must be hanging down, fully extended.
SOURCE: Acura MDX Navigation system is
its really easey to remove the dvd unit under the pasenger seat. just put the seat all the way forward and pull the plastic guard from the seat track (pull straight back) then unplug the harness connectors in the back of the unit.
Then put the seat all the way back and remove the 1o mm nuts on the side brackets of the unit and pull it forward.
SOURCE: 2006 Acura MDX bluetooth stopped
Bluetooths have batteries, Rechargeable. If it won't hold a charge replace the batt.
SOURCE: 2004 Acura MDX Water Leak
The 2002 MDX I worked on turned out to be a drainage problem . Seems the factory installed foam in the bottom of the hinge pillar post which blocked the drain holes . Take off the mud flap , remove enough of the splash shield to access the bottom of the hinge pillar and drill a half inch hole at the front lower corner aiming the drill slightly upward ( be sure to protect the bare metal) .Water gushed out when I did this. For extra ins. remove the kick panels and check for two holes a few inchs from the floor, plug and chaulk these holes. Hope this worksfor you too
SOURCE: Need to reset the code my Acura MDX navigation
check the side of the glove box. my TL has it on the outside side panel as you look from the driver side. my honda prelude had the code there as well. hope this helps
1,293 views
Usually answered in minutes!
×