SOURCE: Carburetor Tuning Mitsubish.
As far as i know, original stock carburetor for Lancer 1989-1992 engine 4G15 12 valve is Aisan Variable Venturi. It have 3 screws :
- air-fuel mixture screw
- main jet adjusting screw
- idle adjusting screw
and here's the document you may need :
http://www.mitsubishi-motors.kiev.ua/info.php?id=20
http://www.lilevo.com/mirage/
Good luck !
Winz
SOURCE: need valve adjustment for 1998 lancer 4g15 engine
I take it you mean 4g13 engine
if so inlet mm 0,20 HOT
ex mm 0,25 HOT.
SOURCE: My 1994 Mitsubishi Lancer (4g15) engine stops
Fuel pump
Testimonial: "It's the fuel pump indeed. Also the gas tank found to be very dirty. The fuel pump was replaced, fuel system cleaned, now the car runs perfectly."
SOURCE: 1994 Mitsubishi Lancer 12valve 4g15
I have a 1994 1.5 litre Mitsubishi Lancer with a 12 valve engine. Located to the right of the rocker cover is the distributor and coil assembly. I have to replace the coil because the old one died. I can remove everything with ease except for a small spring loaded plate that appears to have been pressed onto the shaft. How can I remove that plate without damaging the shaft so that I can replace the coil?
71 views
Usually answered in minutes!
×