How do I change a power steering pressure hose on a 2007 GMC Acadia.

SOURCE: My power steering pressure hose has a leak.

i pERSONALY WOULD REPLACE IT MYSELF EVEN WITHOUT MY 30yrs Of Experience in this Field. I have Enclosed Instructions for you to use. PLEASE dont Forget to RATE me As MOST folks DONT remember to that is how WE Get our Ratings such as GURU THANK YOU and Good Luck On The Job, Dont PAY a dime If YOU CAN > D I Y

REMOVAL PROCEDURE

1. Remove the power steering pressure hose (2) from the power steering pump (1).
2. Raise the vehicle on a hoist. Refer to Vehicle Lifting.
3. Remove the front exhaust pipe, automatic transmission only. Refer to Intermediate Pipe Replacement in Exhaust System
4. Remove the power steering pressure hose (1) from the power steering gear (3).
5. Remove the power steering hose retainer (2).
6. Remove the power steering pressure hose (1) from the vehicle
   1. Install the power steering pressure hose (1) to the vehicle
   2. Install the power steering hose retainers (2). NOTICE: Refer to Fastener Notice in Service Precautions.
   3. Install the power steering pressure hose (1) to the power steering gear (3). Tighten the fitting to 27 Nm (20 ft. lbs.).
   4. Install the front exhaust pipe, if removed. Refer to Intermediate Pipe Replacement in Exhaust System.
   5. Lower the vehicle.
      1. Install the power steering pressure hose (2) to the power steering pump (1). Tighten the fitting to 27 Nm (20 ft. lbs.).
      2. Bleed the power steering system. Refer to Bleeding Power Steering System in Service and Repair of Steering.

SOURCE: 2008 gmc acadia low beam light bulb changing

how do you change the low beam light bulb on the 2008 gmc acadia

SOURCE: how to change the headlight on gmc acadia 2007 (driver's seat)

the low beam bulb?? it's not that hard turn the wheels to gain access to the wheel well and loosen the inner fenderliner (plastic) to gain access to the back of the headlamp assy

SOURCE: how to replace headlight on 2007 gmc acadia

first if you are changing the bulb only and it is a HALOGEN
there is a round acess hole in the inner fender remove it and change the bulb
if you have HID lights or are changing the head light assembly then you have to remove the front bumper facia
hope this helps
hope you have HALOGEN lights

SOURCE: LOW OIL PRESSURE ON 2007 GMC SIERRA 1500. CHANGED

have it tested using a manual gage if still low then main baring ore most likely bad that would mean a over hall if is really low and bearings bad should be making rattle noise when started up first few seconds

Testimonial: "thanks alot.truck is not making a rattling noise.we did check it with a manual gauge.it read about 10 at idol. press. gets better as you incr speed"