SOURCE: replace the alternator on a 97 isuzu rodeo
from Yahoo answers
The alternator is located on the passenger side of the motor at the bottom. There is a bracket attached to the motor and the alternator. You need not take the bracket off to remove the alternator. Two bolts hold the alternator to the bracket. One bolt is on the front top of the alternator and one bolt is located on the bottom front of the alternator. The bottom front bolt is attached to the tension adjustment for the alternator. Loosen the tension screw then remove the bolt going through the tension adjustment. After you loosen the top, front bolt, the alternator should be loose enough to move side to side. Remove the top, front bolt. Now you must disconnect the alternator from the power supply. Behind the alternator is a screw with a wire attached via nut. Remove this wire. Nextly there is a series of wires with a plug on the end. It is plugged into the side of the alternator. Uplug this item. You can also access both of these from the passenger side front tire well. Something to consider is that remanufactured alternators in Rodeo's as well as the Honda Passport (which has the same engine as the Rodeo) do not work and the problem(s) associated with a bad alternator,ie; not charging, no fan blower, battery light and brake light on, still exsist after replacing alternator with reman. Use a factory original alternator if possible. It will cost a little more than a reman but will most likely save you a lot of time and headache!
Hope this helps you out!!
L
SOURCE: Blower Motor Resistor for front AC/Heater
remove glove box....its in the casing near motor.....2 screws and 1 connector
SOURCE: where is air cabin filter located on 99 isuzu rodeo?
its usually behind the glove compartment in the blower box. you will have to pull the GB door down all the way to access it
SOURCE: Dash Lights 1995 Isuzu Rodeo
with lights off and battery disconnected remove the twist knob on the dash that brighten and dims your dash lights and jump the two prongs with a jumper wire. connect battery and turn lights on all your dash lights should work now. if thay don't take the dash screws out and replace the bulbs, it's really easy if you have mechanical skills if not consult a friend that does. now you know the dash light dimmer switch is bad and they are hard to find i found mine in a wreck but until i did i just left the jumper wire in place (about a year and 1/2)
SOURCE: water pump replacement 96 isuzu rodeo
Remove belt, fan, fan shroud and fan bracket. Remove timing covers, timing belt and water pump. Replace timing belt and the hydraulic tensioner with new ones. I suggest you get a mechanic to do this as you can easly get it out of time. Not an easy job.
372 views
Usually answered in minutes!
×