98 lexus es 300 speed sensor A location

Check the wheel speed sensor it could be dirty with metal shavings or crusted brake fluid not allowing it to work properly

Bank one should be the side next to the firewall, and sensor one is before the catalytic converter.

sounds like the shift solenoid or speed and wheel sensors,probably still have the same ones,also check tcm










TIM....

Toyotas and Lexus cars have some unique feaures. If your fuel cap is loose or the O2 sensors on the exhaust are faulty this results in an emission problem and the engine computer unit (ECU) engages the check engine light and disables the VSC (the VSC light comes on to warn you that it has been disabled). However you have p0500 code which says the car has no speed sensor signal. The seed sensor is located on the side of the final drive from the transmission and its job is to measure the speed of rotation of the output shaft. The ECU will compare the signals from this shaft along with the speed sensors in the wheel hubs. If there is a difference between these signals the VSC is engaged to apply braking effort to which ever wheel is slipping (running faster) than the other or that the transmission speed sensor would warrant.
So you either have an emission fault has fed back to the VSC and speed sensor missing (p0500) condition, or you have a faulty sped sensor which has tripped the VSC light and in turn the CEL.
Check your fuel filler cap is on tight, turn radio off and disconnect the negative lead to the battery for 5 minutes (this should clear the ECU memory of the code error). If p0500 error and CEL and VSC lights come back on then check the electrical connection to the speed sensor. Ensure it is clean and making a good contact, check the wiring for continuity. If everything else looks good consider changing the speed sensor.

on the transmission next to axle right hand side

bank 2 sensor 1 is the one you see when facing your exhaust manifold on the right

according to the manual i have... it has three.... one in the exhaust manifold.... and two in the exhaust pipe..... slightly vauge on the exact location of the last two sensors... but looks like it is after the catylitic converter.

engine light keeps comeing on n sometimes the battery light comes on my 94 lexus es 300 wat does tat me

Need to remove the upper and lower air intake manifold.  There are two knock sensors for the front and rear pistons banks.  If you plan to do this yourself it is about 1 to 2 hours.  While you are at it, there is a short coolant bypass hose sitting in the same spot, replace it.  Another problem with the knock sensor is the wire harness used to connect the two knock sensors into one connection sometimes wears out and contacts the metal on the engine causing false signals to the ECM, so replace this cable also.
Just did this last summer on my 99 ES300.  Pretty easy.
DIYr