I have a 2017 Jeep Compass and it has the start stop feature. so on 3 occasions when I have come to a stop the engine actually shot off and I have to put the car in park and press the start button
SOURCE: 2001 jeep grand cherokee the compass/temp
Before replacing the module ($$$$) check the temperature sensor at the front of the vehicle behind the bumper or grill. A reading of -40 indicates a high resistance (NTC resistor sensor). This is probably due to water ingress on a connector causing the high resistance. But could be a bad sensor too. You can also check the module by unplugging the temperature sensor and shorting the two wires that go back to the module together. Shorting the two wires together should show an off scale high reading like 120 or 130 degrees. If it does then the module is OK the problem is the wiring or the sensor. You can use this method to check the wiring all the way up to the module incase there is high resistance in the wiring between the module and the temperature sensor.
SOURCE: installing new sparkplugs on jeep compass
Gap is the same as original ones...should be on an under-hood sticker...Likely 35.
SOURCE: remove 2007 jeep compass bumper cover
Hello, I can assist you. Begin by rounding up the necessary tools:
7mm socket and ratchet
7mm wrench
10mm socket
screw driver or panel removal tool (for push rivets)
Now go to the following site and take a look at the step by step instructions and pictures which does a nice job of explaining this entire job. Thanks for using Fixya!
http://www.jeeppatriot.com/forum/showthread.php?t=6291
SOURCE: temp and compass stopped working
The overhead console is quite prone to internal failure. Dim, intermittent, or dead displays are a common symptom of an internal failure. We offer a reasonable repair service with a lifetime guarantee. Check it out: www.autoclockrepair.com
SOURCE: 2007 jeep compass. compass will start, but will
yake the cover from the stik off,at passanger sideu will see a white paastic that is conected tu a valve ,falow that mecanis and you will get it to a cable that goes all the way up to your egnition ,from the egnision to tha little plasti you will find that the cable is lose or off the track
285 views
Usually answered in minutes!
×