SOURCE: Rear seat removal 2000 merc Villager
fold top seat down first
then there is seat clip push seat forward with upward motion
this releases back floor clamps once released pull seat back this releases the front clamps then pull seat out of back door
SOURCE: Mercury Villager headlight assembly diagaram for removal
This is easy. Lift the lid open. Look at the back of the sealed beam and you will see a clip and an o ring. Pull the clip up and pull wires back toward the driver's seat. Unscrew the o ring and firmly pull the bulb out toward the driver again. Note the 3 tabs on the bulb seat and realign the new bulb with those tab ( 2 bottom, 1 top). Replace with #9007 bulbs..do them both.
SOURCE: where is a knock sensor for 1998 Mercury Villager located?
Here is a image of it's location, I hope it helps.
SOURCE: Code reader knock sensor where is it located
According to the Haynes manual it is under the intake manifold, Upper and lower intake manifolds must be removed for access. If you go to Auto Zone, they have the sensor and can give you the step by step instructions to replacing the knock sensor with common tools. Good luck and hope this help.
SOURCE: How do I change t he thermostat on a 1998 Mercury
where is thermostat on 1998 mercury villager
85 views
Usually answered in minutes!
×