Fuel pump location

SOURCE: where is the fuel pump shutoff switch located on a 1996 chevy silverado 1500 located

Should be on the passenger side kickplate below the glovebox and to the right. You may have to remove the plastic panel to access it or look for a small hole in it and feel around for the button

SOURCE: location Fuel Tank Pressure Sensor on a 2005 chevy express van

lOOK UNDER THE REAR OF THE VEHICLE ABOVE THE SPARE TIRE ON A CROSSMEMBER BETWEEN THE FRAME RAILS.

Marvin

• 85242 Answers
• Posted on Apr 27, 2009

SOURCE: fuel pump relay for a 1994 Chevy Truck WT1500

The Fuel Pump Relay is located in the Glove Box under a little cover on the upper left side. The Fuel Control Relay is the left relay and The Fuel Pump Relay is the right. To test these relays, swap them and then try to start the vehicle, or blow the horn. If the horn blows then use that relay for the pump and you may at least drive the vehicle where needed! If the vehicle starts, then replace them as a pair.

SOURCE: where is the fuel pump relay located in a 1997 chevy blazer 4-dr.

In the glove box behind a plastic panel. There are 3 relays in there. The fuel pump is the one closest to the drivers side.

SOURCE: fuel gauge bouncing on 2000 chevy tahoe where is fuel pump relay

I had previously replaced the failing fuel pump on my '98 K2500 when it went out entirely. I was ready to replace my 2000 K3500's fuel gauge as it was acting up.
When I started the engine, the gauge would bounce from the middle to way past full then back. It would also jump sporadically while driving on level ground.
I checked the electrical connections at the tank and made sure the frame ground strap located nearby was making good contact. Nothing changed until I removed the instrument panel and cleaned the connections on the back. The fuel gauge seems to be operating correctly now.
There are videos on YouTube that show how to remove the instrument cluster if in doubt. Mine dash has a pop-in plastic bezel followed by 4 screws to hold the cluster in place. It took about a half hour to inspect & clean the dash connection vs. $250 to replace the pump/sending unit combo. Hope this helps.