Need wiring diagram for 6 way power seats on 97 blazer

If you have power to the motor and wont move then replace motor, if not they usually run under the door plate, common cause for erosion. the under side gets rusted away and lets in moisture, check fuse and relays, also make sure the battery small wire to ground is intact and making good ground connection. Older vehicles lost power to seats without this chassi ground

And it won't. You probably jumped too many years, And definitely the plugs. 6 to 10. Power and ground is there, Just at the wrong spot. You need pin outs for both. Alldatadiy.com. You can buy them both.

The easiest way to repair this is to find your short to ground and not "butcher' 'the factory harness. It sounds to me like you know some about the system you are repairing so just check the 3 feet of wire that runs from the seat to up under the dash... I'm sure you will be able to locate it. It all runs under the carpet and trim up under the drivers side of the dash.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_4c166ba81493f541

I think that more than likely wher eit draws the power in the fuse box the circuit feed to the fuse is burnt out ,this is often a strip on the back of the fuse box that runs across the frrd to the fuses so check for a feed in the fuse box on the fuse for the power seat

Test the electrical circuit , Using a DMM - digital muti-meter an wiring diagram ! Voltage drop testing ,
Mastering Voltage Drop Testing with Pete Meier and Jerry Truglia
Electric Testing Techniques You Need to Know
Free wiring diagrams here http://www.bbbind.com/free_tsb.html
Enter vehicle info. year , make , model an engine size . Under system click on body & accessories ,then under subsystem click on power windows . Click the search button ,then blue link.
Check for broken wire's inside the flex connection from body to door .

u have 2 jump the wires over with a12volt bat just get ur seat wires find a ground and dont pull ur hair out uit takes sum anger management

The most common cause of this is that the electric heating grid in the seat is defective. To repair this the seat must have the cover removed and a new grid installed, you will likely need to replace the control switch at the same time, also look under the seat and make sure no wiring is damaged on the seat support springs and shorted to ground. The de-trimming (removal of seat coverings) is best left to automotive trim shop as removing and installing a seat cover is a real pain if you don't have the correct tools and skills to remove the retaining clips that hold the cover to the frame, they are called "hog rings".

CHECK POWER SEAT FUSE.IF FUSE OKAY.CHECK FOR POWER AT SEAT SWITCH IF YES.HOT WIRE POWER SEAT MOTOR STILL DONT WORK. POWER SEAT MOTOR FAULTY.NO POWER TO SWITCH AND FUSE GOOD CHECK FOR A OPEN OR BROKE WIRE FROM THE FUSE BOX TO THE POWER SEAT SWITCH.

here is the seat diagram SEAT

Hope it helps

yes they will same plug in