SOURCE: cold air on passenger side warm air on drivers side
Actuator motors either get a tear in the rubber or a hose is broken and not letting vacuum assist in its opening.
You can try moving the lever by hand and see if the air gets colder on the bad side.
SOURCE: Replace 2007 Toyota Rav4 super sport passenger side door mirror
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
SOURCE: need to locate blend door actuator on 2002 ford
Open the glove box,and look on top of ac/heater box toward the center of vehicle,it should be setting right there.
SOURCE: What do I have to remove to access blend door actuator
very lenghty process. too long to describe here....go to Bonneville Forums read the text and follow linked there at the bottom....very good and detailed....I'm doing that right now,,,,it is a bugger,
SOURCE: The driver side only blows
Yes it is most likely a vacuum actuator there are more then one . They open and close little doors in the ducts to deriect air flow inside the ducts . They are not easy to get at in most cases however you should look at all vacuum lines going to and near the unit its controlled by engine vacuum . exhust all other opptions first before takeing the dash out . The problem could also be electrical check the control switches make sure the switch is not bad on one side . Spend some time looking and thinking before you start riping things apart. Good luck with it
1,633 views
Usually answered in minutes!
×